/live/media/CR/CR_32502_Fro.jpg)
SKF 32502 Wheel Seal - Rear
| Brand | SKF 32502 |
|---|---|
| Position | Rear |
| Width | 0.438 |
| Outside Diameter | 4.506 |
| Sealing Surface Type | Nitrile |
| Shaft Diameter | 3.250 |
| Fits | — |
Nitrile sealing surface. Helps keep lubricants in and contaminants out.
Precision-made seal. Built to specific designs for the right application and environment.
SKF seal heritage. Backed by decades of seal design and development experience.
Cross-references Karlyn 107, OSC 13044 and Walker Exhaust 47792 for the same application. See all 10.
SKF 32502 Wheel Seal Overview
SKF 32502 is a wheel seal built for driveline and axle sealing applications where controlled lubricant retention and contamination control matter. With a nitrile sealing surface and precise dimensional specs, it is suited for service work that calls for a direct-fit wheel seal replacement.
For technicians searching for a wheel seal for axle service, SKF 32502 offers the dimensional consistency needed for a proper seal at the shaft and housing interface. It is a practical choice for wheel seal replacement on vehicles such as Honda Civic and similar applications that use this size profile.
Key Features
- Part number: SKF 32502
- Wheel seal for driveline and axle sealing systems
- Nitrile sealing surface type for sealing performance in automotive service
- Outside diameter: 4.506 in.
- Shaft diameter: 3.250 in.
- Width: 0.438 in.
- Built to SKF design and manufacturing standards
Detailed Description
SKF has a long history in seal engineering, and the 32502 wheel seal reflects that focus on material selection and dimensional accuracy. The nitrile sealing surface is specified for sealing applications where lubricant retention and contaminant exclusion are critical. With a 4.506-inch outside diameter, 3.250-inch shaft diameter, and 0.438-inch width, this seal is intended for applications that require those exact measurements. This part number, 32502, is commonly searched by buyers looking for an OE-style wheel seal replacement for axle and hub service.
This part cross-references Karlyn 107 and OSC 13044 for the same application.
What It Is Used For
- Stopping gear oil or grease leakage at the wheel end
- Keeping dirt, water, and road debris out of the axle assembly
- Replacing a worn or hardened wheel seal during hub service
- Addressing seal wear that can lead to bearing contamination
- Supporting proper lubrication retention in driveline and axle systems
Installation Notes and Tips
Verify shaft diameter, outside diameter, and width before installation to confirm the seal matches the application. Inspect the sealing surface, hub bore, and axle shaft for wear, scoring, or corrosion before fitting SKF 32502. Clean all mating surfaces thoroughly and install the seal squarely to avoid distortion or premature leakage. Confirm the vehicle application by part number and dimensions when servicing Honda Civic wheel seal applications or other vehicles using this seal size.
Quality Assurance
SKF designs and manufactures seals to specific application requirements using premium materials and established quality standards. The brand’s seal engineering background supports consistent fit and long service life in automotive driveline service. Part number 32502 is built for dependable sealing performance in wheel seal replacement work.
| Year | Make | Model | Position | Notes |
|---|---|---|---|---|
| No rows match your filter. | ||||