SKF 541478 Wheel Seal - Front

SKF 541478 Wheel Seal Overview

SKF 541478 is a wheel seal built for driveline and axle sealing applications where lubricant retention and contamination control matter. With a nitrile sealing surface and precise dimensional sizing, it supports dependable sealing performance for service work on vehicles such as Honda Civic and Toyota Corolla applications where the correct wheel seal dimensions are critical.

This SKF wheel seal, part number 541478, is engineered to match the shaft and housing dimensions required for a proper seal. It is a practical choice when replacing a worn seal that has started to leak grease or allow road debris into the hub area.

Key Features

• Nitrile sealing surface for sealing performance in wheel-end applications
• Outside diameter: 2.254 in.
• Shaft diameter: 1.625 in.
• Width: 0.313 in.
• SKF part number 541478 for accurate ordering and service reference

Detailed Description

SKF has a long history in seal design and manufacturing, and this wheel seal reflects that experience with application-specific construction and premium materials. The seal is designed to help keep lubricants in place while blocking contaminants from entering the wheel-end assembly. For technicians and DIY repairs, the key dimensions—2.254-inch outside diameter, 1.625-inch shaft diameter, and 0.313-inch width—make it easier to verify the correct replacement before installation. If you are servicing a Honda Civic or Toyota Corolla wheel-end repair, confirming these measurements against the original part is essential. The SKF 541478 is also cross-referenced to Monroe Shocks & Struts 27SS5196 and 4135196100 for the same application.

What This Wheel Seal Helps Address

• Grease seepage at the wheel-end seal area
• Contamination entering the hub or axle sealing surface
• Noise or wear caused by degraded sealing material
• Loss of lubricant protection in the wheel-end assembly
• Repeat repairs caused by an incorrect seal size

Installation Notes and Tips

Verify the shaft diameter, outside diameter, and width against the removed seal before installation. Clean the sealing surfaces thoroughly and inspect the hub or axle area for scoring, corrosion, or damage that could affect seal life. Use proper seal installation tools to avoid distorting the nitrile sealing lip or damaging the housing. Confirm the vehicle application by part number and dimensions when servicing Honda Civic or Toyota Corolla wheel-end components.

Quality Assurance

SKF manufactures seals to defined specifications using materials selected for the application and operating environment. The brand’s seal engineering focus and long-standing production experience support consistent fit and sealing performance for service replacement use.