SKF BR119 Transfer Case Output Shaft Bearing - Rear Forward

SKF BR119 Transfer Case Output Shaft Bearing

SKF BR119 is a tapered roller bearing set for transfer case output shaft service, built for smooth, quiet rotation under drivetrain load. With precise dimensions and application-specific fitment for Toyota and Lexus rear forward transfer case positions, it supports accurate replacement on common AWD platforms.

Key Features

• Tapered roller bearing set for transfer case output shaft applications
• Inside diameter: 1.574 in.
• Outside diameter: 3.346 in.
• Width: 0.974 in.
• Logarithmic roller raceway profile with a smooth surface finish for consistent operation
• SKF BR119 is manufactured to high quality standards for long service life and safety

Detailed Description

The SKF BR119 transfer case output shaft bearing is engineered for vehicles that rely on precise drivetrain support, including 2001-2013 Toyota Highlander, 2004-2010 Toyota Sienna, 2007-2009 Lexus RX350, 2004-2006 Lexus RX330, 2001-2005 Toyota RAV4, and 1999-2003 Lexus RX300 in the rear forward position. This bearing uses tapered roller construction to handle combined radial and axial loads while maintaining stable shaft alignment in the transfer case. The BR119 part number is a direct reference for shoppers searching for a Toyota Highlander transfer case output shaft bearing or a Lexus RX350 rear forward bearing replacement.

SKF has more than 100 years of engineering experience in bearing design, and this part reflects that focus with a refined raceway profile and smooth finish intended to reduce noise and promote consistent rotation. If you are replacing a worn transfer case bearing on a Toyota Sienna, Toyota RAV4, or Lexus RX300, SKF BR119 provides the dimensional accuracy needed for a proper service fit. This part cross-references 9036640036 for the same application.

Common Problems This Part Can Address

• Transfer case bearing noise during acceleration or deceleration
• Excessive drivetrain vibration from worn output shaft support
• Rough or inconsistent transfer case rotation
• Play at the output shaft caused by bearing wear
• Noise complaints on AWD Toyota and Lexus vehicles with rear forward transfer case placement

Installation Notes and Tips

Confirm the transfer case position before ordering, since this bearing is listed for the rear forward location only. Measure the shaft and housing dimensions against the published inside diameter, outside diameter, and width to verify the correct service part. During installation, inspect the output shaft, races, and surrounding seals for wear or scoring, and replace any damaged components before reassembly. Cleanliness and correct bearing seating are important for quiet operation and long-term durability.

Quality Assurance

SKF manufactures this bearing to high quality standards and designs it for long service life and safety in drivetrain applications. The BR119 is built for precise fitment in supported Toyota and Lexus transfer case applications.