SKF BR52 Manual Transmission Bearing

SKF BR52 Manual Transmission Bearing

SKF BR52 is a tapered roller bearing set for transmission and differential service where precise fit and smooth rotation matter. With a 1.312 in inside diameter, 2.687 in outside diameter, and 0.875 in width, this bearing is built for applications that demand stable support and quiet operation.

Key Features

• Tapered roller bearing set for manual transmission and differential use
• 1.312 in inside diameter for application-specific shaft fit
• 2.687 in outside diameter for housing fitment
• 0.875 in width for correct bearing stack-up
• Logarithmic roller raceway profile for smoother rolling contact
• Ultra-smooth surface finish for reduced noise in operation
• SKF engineering and manufacturing standards for long service life

Detailed Description

The SKF BR52 is a precision tapered roller bearing set used in transmission and differential assemblies across a wide range of vehicles. It is commonly searched for by drivers and technicians working on Ram 1500 rear outer applications, Ford F-150 rear outer service, and Chevrolet Silverado 1500 front outer or rear outer differential repairs. This part number, BR52, is also referenced in fitment for Jeep Wrangler, Dodge Dakota, and GMC Sierra 1500 applications.

SKF uses a logarithmic roller raceway profile and a refined surface finish to promote smooth, quiet rotation under load. That matters in manual transmission and differential service, where bearing condition directly affects gear support, noise, and drivability. This part cross-references 087-409-551-B and 1458BR52 for the same application.

What It Helps Fix

• Gear whine from worn transmission or differential bearings
• Excessive play in the bearing race or shaft support area
• Rough rotation caused by pitting, wear, or heat damage
• Noise during acceleration, deceleration, or cruising
• Loss of smooth operation in rear outer or front outer bearing locations

Installation Notes and Tips

Verify the bearing dimensions before installation: 1.312 in inside diameter, 2.687 in outside diameter, and 0.875 in width. Confirm the axle, ring gear, and position details in the vehicle listing before ordering, especially on Ram 1500, Ford F-150, and Chevrolet Silverado 1500 applications. Clean the housing thoroughly, inspect the race and related components for wear, and replace any damaged mating surfaces before assembly.

Because this bearing is used in multiple positions including rear outer, front outer, rear inner, front, outer, and front inner locations, match the exact application notes to the vehicle configuration.

Quality Assurance

SKF has supplied bearing solutions for more than 100 years and manufactures components to strict quality standards for durability and safe operation. BR52 is built for consistent performance in demanding drivetrain service.