SKF CIR212 Wheel Bearing Retaining Ring - Front

Wheel Bearing Retaining Ring for Front Hub Service

SKF CIR212 is a wheel bearing retaining ring used with generation one wheel bearings to secure the bearing inside the steering knuckle. For front-end service on Toyota Highlander and Lexus RX applications, replacing a rusted or damaged C-clip helps restore a secure bearing fit during hub and bearing work.

Key Features

• Wheel bearing retaining ring for generation one wheel bearing applications
• Inside diameter: 3.142 in.
• Width: 0.236 in.
• Outside diameter: 3.614 in.
• Built to meet or exceed OEM specifications
• Direct replacement for SKF CIR212 service applications

Application Details

SKF CIR212 is used to retain the wheel bearing inside the steering knuckle after hub service. It is a practical replacement when the original C-clip has corrosion, distortion, or wear from removal. This part cross-references 9052079002 for the same application. Fits 2008-2019 Toyota Highlander, front. Fits 2010-2016 Lexus RX350, front. Fits 2010-2016 Lexus RX450h, front.

What It Helps Address

• Loose or insecure wheel bearing retention in the steering knuckle
• Corrosion on the original retaining ring
• Damage from bearing or hub removal
• Improper bearing seating during front hub service
• Repeat repairs caused by reusing worn retaining hardware

Installation Notes

Inspect the steering knuckle and bearing seat before installation. Replace any retaining ring that shows rust, stretching, or deformation. Confirm the ring dimensions match the bearing and knuckle specification before assembly. Use during front wheel bearing and hub service on the listed Toyota Highlander and Lexus RX applications.

Quality Assurance

SKF manufactures this retaining ring to meet or exceed OEM specifications and test requirements. SKF has supplied drivetrain and bearing solutions for more than 100 years, and CIR212 follows that engineering standard for front wheel bearing retention.