SKF CIR237 Wheel Bearing Retaining Ring - Front or Rear

SKF Front Wheel Bearing Retaining Ring CIR237

SKF CIR237 is a front wheel bearing retaining ring for generation one wheel bearings that secure the bearing inside the steering knuckle. It is built to OEM specifications for a precise fit on applications such as Volkswagen Jetta, Volkswagen Beetle, Audi TT, and Mazda Miata front or rear wheel bearing service.

Key Features

• Inside diameter: 2.728 in.
• Outside diameter: 3.090 in.
• Width: 0.076 in.
• Front wheel hub retaining ring for generation one wheel bearings
• Made to meet or exceed OEM specifications
• SKF part number CIR237

Product Details

The SKF Wheel Hub Retaining Ring (s) -Front line is focused on retaining-ring service for wheel bearing and hub assemblies. CIR237 is used to hold the bearing in the steering knuckle, helping maintain a secure bearing location during wheel bearing replacement or hub service. This part cross-references OE number N90663201 for the same application. For Volkswagen Jetta front wheel bearing service, Audi TT front or rear applications, and Mazda Miata rear service, the correct retaining ring dimensions matter for proper seating and retention.

SKF has supplied drivetrain and chassis hardware for more than 100 years, and this retaining ring reflects that experience with dimensions and specifications intended to match OE requirements. The CIR237 part number is also useful when searching for a direct replacement retaining ring for front wheel hub service on select Volkswagen, Audi, and Mazda models.

Common Problems This Part Helps Address

• Rusted retaining rings that are difficult to remove during wheel bearing service
• Damaged clips that no longer hold the bearing securely in the knuckle
• Improper bearing retention after hub or bearing replacement
• Fitment issues caused by worn or distorted original C-clips
• Noise or looseness related to a bearing that is not seated correctly

Installation Notes and Tips

Replace the retaining ring whenever the original clip is rusted, bent, or damaged during removal. Confirm the bearing generation and verify the ring dimensions before installation. Clean the steering knuckle groove thoroughly so the new ring seats fully and retains the wheel bearing as intended. Use the vehicle-specific fitment data to confirm whether CIR237 applies to the front or rear position on your Volkswagen Jetta, Volkswagen Beetle, Audi TT, Audi A3, Mazda Miata, or Kia Sephia application.

Quality Assurance

SKF manufactures this retaining ring to meet or exceed OEM specifications and test requirements for dependable wheel bearing retention. That OE-focused approach supports consistent fit and long service life in wheel hub repair work.