SKF CIR502 Wheel Bearing Retaining Ring - Rear
OE Quality 60-Day Returns
SKF

SKF CIR502 Wheel Bearing Retaining Ring - Rear

Brand SKF CIR502
Position Rear
Inside Diameter 2.220
Width 0.209
Outside Diameter 2.535
Fits Ford · 3 vehicles

OEM-spec C-clip retainer. Made to meet or exceed OEM requirements for a secure bearing fit.

Replacement-ready design. Helps replace worn clips that can rust or damage during removal.

SKF engineering. Backed by more than 100 years of drivetrain and hardware expertise.

Cross-references 9S4Z7059A for the same application. See all 1.

$10.46Free shipping
In stock · usually ships same day before 1pm CST
Step 1 — Confirm fitment
Free return shipping if it doesn't fit when you check fitment here first.

Select your vehicle to confirm fitment
Verify this part fits before purchasing — free returns if it doesn't
Step 2 — Quantity
Order total $10.46
Free shipping to the continental U.S.
Free returns within 60 days if it doesn't fit when fitment is verified.
Not what you need? See all Wheel Bearing Retaining Ring options

SKF CIR502 Wheel Bearing Retaining Ring

SKF CIR502 is a wheel bearing retaining ring for generation one wheel bearings that secure the bearing inside the steering knuckle. For 2009-2011 Ford Focus rear applications, replacing a worn or rusted C-clip helps restore a secure bearing fit during hub or bearing service.

Key Features

  • Inside diameter: 2.220 in.
  • Outside diameter: 2.535 in.
  • Width: 0.209 in.
  • Made to meet or exceed OEM specifications
  • Fits 2009-2011 Ford Focus, rear
  • SKF part number CIR502 for wheel bearing retention service

Application Details

This retaining ring is used to hold a generation one wheel bearing in the steering knuckle. It is a direct-fit service part for rear wheel bearing retention on 2009-2011 Ford Focus models. This part cross-references Ford (e.g., 9S4Z7059A) for the same application.

Common Problems It Helps Address

  • Rust or corrosion on the original bearing retaining clip
  • Damage from removal during wheel bearing service
  • Loose or insecure wheel bearing retention in the knuckle
  • Improper seating of a new bearing hub unit
  • Repeat service caused by reusing a worn clip

Installation Notes

Inspect the steering knuckle and bearing seat before installation. Replace any clip that shows corrosion, distortion, or wear, and confirm the retaining ring seats fully in the groove before reassembling the hub or bearing components. Verify rear fitment for the 2009-2011 Ford Focus before installation.

Quality Assurance

SKF manufactures this retaining ring to meet or exceed OEM specifications and test requirements. SKF has supplied driveline and bearing-related components for more than 100 years, and CIR502 follows that engineering standard for consistent fit and service life.

This part fits 3 vehicles
Always verify fitment with your vehicle's VIN if unsure. Submodel & trim restrictions may apply.
YearMakeModelPositionNotes
2011FordFocusRear—
2010FordFocusRear—
2009FordFocusRear—
Directly replaces or cross-references 1 part number
Cross-reference numbers are provided for identification purposes only. Always confirm fitment before ordering.
9S4Z7059A