SKF FW34 Wheel Bearing - Front

SKF FW34 Wheel Bearing for Front Applications

The SKF FW34 wheel bearing is built for front wheel service on select Mitsubishi models, with dimensions that matter for proper hub support and smooth rotation. Its 1.574-inch inside diameter, 1.574-inch width, and 3.149-inch outside diameter help ensure the bearing matches the required fitment for the application.

Compatible with 2002-2006 Mitsubishi Lancer front and 2003-2006 Mitsubishi Outlander front, the SKF FW34 is a direct-fit wheel bearing choice for drivers and technicians servicing these vehicles.

Key Features

• SKF FW34 front wheel bearing for driveline and axle service
• 1.574 in inside diameter for correct shaft interface
• 1.574 in width for application-specific bearing support
• 3.149 in outside diameter for proper hub seating
• Sealed wheel bearing design for front-end service on Mitsubishi Lancer and Mitsubishi Outlander
• Interchange reference: MR491449

Detailed Description

SKF has a long history in bearing technology, and the FW34 reflects that engineering focus with precise dimensional sizing for front wheel applications. The bearing’s sealed construction supports consistent operation in the hub assembly while helping maintain smooth wheel rotation under everyday driving loads. For 2002-2006 Mitsubishi Lancer front and 2003-2006 Mitsubishi Outlander front service, SKF FW34 provides the dimensional accuracy needed for a proper repair. This part number, FW34, is a practical choice when replacing a worn front wheel bearing on Mitsubishi Lancer or Mitsubishi Outlander models.

This part cross-references MR491449 for the same application.

What It Helps Address

• Front wheel bearing noise during driving
• Excessive wheel play or looseness at the hub
• Rough or uneven wheel rotation
• Vibration traced to a worn front bearing assembly
• Service needs on Mitsubishi Lancer and Mitsubishi Outlander front hubs

Installation Notes and Tips

Verify hub and spindle dimensions before installation and compare the old bearing to the SKF FW34 to confirm the inside diameter, width, and outside diameter match the application. Clean the mating surfaces thoroughly, inspect the hub for wear or scoring, and follow the vehicle service procedure for bearing replacement. For best results, confirm front-position fitment before assembly on the Mitsubishi Lancer or Mitsubishi Outlander.

Quality Assurance

SKF manufactures bearing products to high quality standards, drawing on more than a century of bearing engineering experience. The FW34 is produced with attention to dimensional accuracy and long-service performance for front wheel bearing applications.