SKF SET412 Wheel Bearing - Front Inner or Rear Inner

SKF SET412 Wheel Bearing Set

SKF SET412 is a tapered roller wheel bearing set built for driveline and axle service where correct fit, smooth rotation, and stable load handling matter. With a 2.500 inside diameter, 4.812 outside diameter, and 1.500 width, it is sized for precise bearing replacement in the specified application.

For technicians and owners servicing wheel-end noise or wear on vehicles such as Honda Civic and Toyota Corolla applications, SKF SET412 provides a direct replacement option engineered to meet or exceed common application requirements.

Key Features

• Tapered roller wheel bearing set for wheel-end service
• Inside diameter: 2.500
• Outside diameter: 4.812
• Width: 1.500
• Logarithmic roller raceway profile for smoother operation
• Ultra-smooth surface finish to support quiet running
• SKF SET412 cross-references Dorman - HELP 15790 for the same application

Detailed Description

SKF SET412 is part of SKF’s tapered roller bearing set lineup, designed for applications that require accurate bearing geometry and dependable wheel support. The bearing’s profile and finish are intended to reduce friction and promote consistent operation under normal driveline and axle loads. If you are replacing a worn wheel bearing on a Honda Civic, Toyota Corolla, or another vehicle using this size specification, SKF SET412 offers a precise service part identified by part number SET412.

SKF has supplied bearing and driveline components for more than a century, and this set reflects that focus on dimensional accuracy and manufacturing consistency. The 2.500-inch inside diameter, 4.812-inch outside diameter, and 1.500-inch width are the key dimensions to verify before ordering.

What It Helps Address

• Wheel bearing noise during driving
• Rough or uneven wheel rotation
• Excessive play from a worn bearing assembly
• Heat or drag caused by bearing wear
• Service replacement for a damaged tapered roller bearing

Installation Notes and Tips

Confirm the bearing dimensions against the removed part before installation. Clean the hub, spindle, and related bearing surfaces thoroughly, and inspect seals and races for wear or scoring. Proper bearing preload and lubrication are important for long service life, so follow the vehicle service procedure for the application. SKF SET412 should be installed only in the vehicle configuration that matches the listed dimensions and application requirements.

Quality Assurance

SKF manufactures this bearing set to high quality standards for dimensional accuracy, smooth operation, and long service life. Part number SET412 is backed by SKF’s established engineering and manufacturing experience in wheel-end and driveline components.