SKP SES800983S Steering Tie Rod End Adjusting Sleeve - Left Outer

Steering Tie Rod End Adjusting Sleeve for Jeep

Restore proper steering linkage adjustment with the SKP SES800983S steering tie rod end adjusting sleeve. This steering hardware component is built for direct-fit service on select Jeep Wrangler applications, including Wrangler JK and Wrangler models with left outer fitment.

• Steering tie rod end adjusting sleeve for steering linkage adjustment
• Fits 2018 Jeep Wrangler JK, N/A
• Fits 2007-2017 Jeep Wrangler, left outer
• Direct replacement for OE-style steering service
• Cross-references MOOG Chassis Products ES800983S for the same application
• Cross-references 52060054AB for the same application

Detailed Product Overview

The SKP SES800983S is a steering tie rod end adjusting sleeve used in the front steering system to help set and maintain correct toe alignment after service. It is a practical replacement for Jeep Wrangler steering repairs where the original sleeve is worn, seized, or no longer holds adjustment. For Jeep Wrangler JK and 2007-2017 Jeep Wrangler left outer applications, this part number supports accurate steering linkage setup.

Common Repair Uses

• Steering wheel off-center after alignment
• Uneven tire wear caused by incorrect toe settings
• Loose or worn steering linkage adjustment points
• Corrosion or seizure in the original adjusting sleeve
• Replacement during tie rod or steering service on Jeep Wrangler models

Installation Notes

Install the sleeve during steering linkage service and verify thread engagement before alignment. Final toe settings should be checked after installation to confirm proper steering geometry. This part fits 2007-2017 Jeep Wrangler, left outer, and 2018 Jeep Wrangler JK, N/A.

Quality Assurance

SKP SES800983S is listed as an OE-style replacement steering hardware part for the specified Jeep applications.