SKP SK936075 Drive Shaft - Rear

Compatible With Select Jeep Wrangler Rear Applications

The SKP SK936075 drive shaft is built for rear driveline service on select Jeep Wrangler models. It is a fitment-specific replacement for vehicles equipped with Sales Code DRJ and the Dana M35/194 mm rear axle.

• Fits 1997-2006 Jeep Wrangler, rear, with Sales Code DRJ (Dana M35/194 mm rear axle).
• Direct replacement format for a vehicle-specific driveline application.
• Part number SK936075 for easy identification and ordering.

Drive Shaft Details

This drive shaft is intended for rear driveline replacement on the Jeep Wrangler platform listed in the fitment data. Because driveline dimensions and axle configuration must match exactly, the Sales Code DRJ note is important when confirming application. Use SK936075 when replacing a worn or damaged rear drive shaft on the specified Jeep Wrangler configuration.

Common Problems It Can Address

• Vibration from a worn or out-of-balance rear driveline component.
• Clunking or driveline noise during acceleration or deceleration.
• Loss of smooth power transfer through the rear axle assembly.
• Replacement need after shaft damage, wear, or corrosion.

Installation Notes and Tips

Confirm the vehicle’s rear axle configuration before ordering, since this part is listed only for Wrangler models with Sales Code DRJ and the Dana M35/194 mm rear axle. Compare the original shaft and mounting points to verify the application matches SK936075. Professional installation is recommended for driveline components to ensure proper alignment and operation.

Quality Assurance

SKP offers this driveline replacement under part number SK936075 for the specified Jeep Wrangler application. Verify fitment against the vehicle’s build information before installation.