SKP SKAS1 Manifold Absolute Pressure Sensor

Manifold Absolute Pressure Sensor Overview

The SKP Manifold Absolute Pressure Sensor, part number SKAS1, measures intake manifold pressure so the engine computer can calculate the correct air-fuel mixture. It is built to meet or exceed OE specifications for fit and performance.

Compatible With Ford truck and van applications, this MAP sensor supports accurate engine management in a wide range of older Ford platforms. If you are replacing a worn MAP sensor on a Ford F-150, Ford F-250, or Ford Bronco, SKAS1 provides a direct-fit service part for the application.

Key Features

• Measures intake manifold pressure for engine control calculations
• Built to meet or exceed OE specifications
• Direct-fit replacement for supported Ford applications
• Helps restore stable air-fuel mixture control
• Part number SKAS1 for easy identification

Detailed Description

SKP SKAS1 is a manifold absolute pressure sensor used by the engine computer to monitor manifold pressure and adjust fueling accordingly. Accurate MAP sensor input is important for drivability, throttle response, and efficient engine operation. This sensor is listed for 1988-1997 Ford applications including F-150, F-250, F-350, Bronco, and Econoline models, making it a practical replacement for aging factory sensors on those vehicles.

For buyers searching for a Ford F-150 MAP sensor, Ford Bronco MAP sensor, or Ford Econoline manifold absolute pressure sensor, SKAS1 offers an OE-spec replacement option. The part number SKAS1 should be matched to the vehicle application before installation.

What It Helps Address

• Erratic idle caused by inaccurate manifold pressure readings
• Poor fuel mixture control from a failing MAP sensor
• Reduced throttle response linked to sensor degradation
• Check engine concerns related to manifold pressure input
• Driveability issues on older Ford engine management systems

Installation Notes and Tips

Verify the vehicle application against the fitment list before ordering. Inspect the vacuum source, electrical connector, and surrounding intake components during replacement to confirm the new sensor can read manifold pressure correctly. Clear diagnostic trouble codes after installation if required by the repair procedure.

Quality Assurance

SKP manufactures this MAP sensor to meet or exceed OE specifications for fit and performance. The SKAS1 part number is also cross-referenced to Monroe Shocks & Struts 172286 and 182286 for the same application.