SKP SKF365HSA Engine Cylinder Head Gasket Set

Engine Cylinder Head Gasket Set for Ford 6.0L Applications

Restore sealing performance in compatible Ford Super Duty and E-Series diesel applications with the SKP SKF365HSA engine cylinder head gasket set. This part is built for direct replacement use where the original setup calls for 20mm dowels.

Key Features

• Engine cylinder head gasket set for sealing the combustion chamber and coolant/oil passages.
• Direct-fit replacement for applications specified with 20mm dowels.
• Fits Ford E-350 Super Duty, F-250 Super Duty, F-350 Super Duty, E-350 Club Wagon, and Excursion applications listed below.
• SKP part number SKF365HSA for easy identification and ordering.
• This part cross-references F365HSA and HS8-20760 for the same application.

Detailed Description

The SKP SKF365HSA engine cylinder head gasket set is intended for repair work on Ford diesel engines where head sealing integrity is critical. It is a fitment-based replacement for 2003-2010 Ford truck and van applications listed with 20mm dowels, including Ford F-250 Super Duty, Ford F-350 Super Duty, Ford E-350 Super Duty, Ford E-350 Club Wagon, and Ford Excursion. Use this gasket set when servicing a leaking or compromised cylinder head sealing surface and when the original application matches the listed fitment.

For buyers searching for a Ford F-250 Super Duty head gasket set, Ford F-350 Super Duty cylinder head gasket set, or Ford E-350 Super Duty engine gasket replacement, SKF365HSA provides a direct reference point for the correct application. The part number SKF365HSA also helps confirm selection against interchange references during engine repair planning.

What It Is Used For

• Replacing a failed cylinder head gasket during engine repair.
• Addressing coolant loss caused by sealing failure at the head gasket.
• Correcting combustion leakage that can affect compression.
• Repairing oil and coolant mixing caused by gasket deterioration.
• Restoring sealing integrity after cylinder head service.

Installation Notes and Tips

Verify engine configuration and dowel size before installation. Confirm the vehicle is one of the listed Ford applications and match the 20mm dowel requirement exactly. Clean and inspect the cylinder head and block sealing surfaces before assembly, and follow the manufacturer service procedure for torque sequence and fastener reuse requirements.

Quality Assurance

SKP identifies this part as SKF365HSA for accurate catalog matching and fitment verification. Always confirm the part number and application details before installation.