Stabilus 5B-309086 Trunk Lid Lift Support

Stabilus Trunk Lid Lift Support for Camaro

The Stabilus 5B-309086 trunk lid lift support is engineered for controlled rear hatch and trunk motion with gas-charged damping. It is a direct-fit style support for select 2016-2017 Chevrolet Camaro Coupe models without a spoiler, using ball socket ends and OE-style dimensions for application-specific performance.

• Part number: 5B-309086
• Gas lift support with dynamic damping for controlled extension and closing
• Compressed length: 8.01 in. / 203.5 mm
• Extended length: 11.91 in. / 302.5 mm
• Stroke length: 3.9 in. / 99 mm
• Maximum force: 55 lb / 245 N
• Ball socket ends with nylon end materials
• Cylinder outside diameter: 0.709 in. / 18 mm
• Inner shaft diameter: 0.315 in. / 8 mm

Application Details

Compatible with 2016-2017 Chevrolet Camaro, N/A, Coupe, 1st Design, w/o Spoiler. If you are searching for a Chevrolet Camaro trunk lid lift support or a Stabilus 5B-309086 replacement for the listed Camaro coupe application, this unit matches the specified fitment and dimensions.

Lift-O-Mat dynamic damping uses a precision groove profile inside the tube to regulate gas flow through the stroke. That controlled motion helps the trunk lid open smoothly and settle gently at the end of travel, which is important for consistent OE-style operation on the Camaro.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Trunk lid that drops too quickly
• Weak or inconsistent lift assistance
• Harsh closing or end-of-stroke impact
• Difficulty keeping the trunk open during service or loading
• Uneven motion caused by a worn gas support

Installation Notes

Verify the vehicle is a 2016-2017 Chevrolet Camaro Coupe, 1st Design, without spoiler before ordering. Match the ball socket end style and compressed/extended lengths to the original support, and replace only after confirming the mounting points and orientation on the vehicle.

Quality Assurance

Stabilus Lift-O-Mat supports are built for application-specific damping and OE-style motion control. The dynamic damping design is used to deliver consistent extension and a controlled final stop for the listed Camaro fitment.