Standard Ignition ALH133 ABS Wheel Speed Sensor Wiring Harness - Rear Left

ABS Wheel Speed Sensor Harness for Sequoia

Standard Ignition ALH133 is an ABS wheel speed sensor wiring harness for the rear left position on select Toyota Sequoia models. It connects the antilock brake speed sensor circuit with the correct female and male blade-terminal interfaces for a direct replacement-style repair.

Key Features

• Fits 2008-2019 Toyota Sequoia, rear left
• ABS wheel speed sensor wiring harness for the antilock brake system
• 2 connector design with oval connector shape
• Female connector gender with male blade terminals
• Built for the rear left wheel speed sensor circuit
• Standard Ignition ALH133 replacement part

Detailed Description

Use Standard Ignition ALH133 when servicing the rear left ABS wheel speed sensor wiring on a Toyota Sequoia. This harness is specified with two connectors, an oval connector shape, female connector ends, and male blade terminals to match the vehicle-side electrical connection used in the antilock brake speed sensor circuit. For buyers searching for a Toyota Sequoia rear left ABS sensor harness or a Standard Ignition ALH133 replacement, this part provides the correct fitment for 2008-2019 model years.

This part cross-references 1P3520 and ABH133 for the same application.

What It Helps Fix

• Broken or damaged rear left ABS wheel speed sensor wiring
• Intermittent wheel speed signal loss at the antilock brake system
• Warning lights caused by an open or poor sensor circuit
• Corrosion or terminal wear at the rear left sensor connection
• Harness damage from road debris, moisture, or vibration

Installation Notes and Tips

Confirm the rear left location before installation and compare the connector shape, gender, and terminal style to the original harness. Inspect the sensor connector, terminals, and nearby wiring for corrosion or heat damage before reconnecting. After installation, clear any stored ABS fault codes and verify wheel speed data during a road test.

Quality Assurance

Standard Ignition is a recognized aftermarket source for electrical and ignition components, and ALH133 is built to match the specified connector and terminal configuration for the listed Toyota Sequoia applications.