Standard Ignition ALH182 ABS Wheel Speed Sensor Wiring Harness - Front Right

OE-Style ABS Sensor Harness for Cadillac SRX

Standard Ignition ALH182 is an ABS wheel speed sensor wiring harness built for the front right position on select Cadillac SRX models. It uses OE-quality connectors and terminals to support a secure, water-tight connection at the chassis wiring interface.

For 2011-2016 Cadillac SRX front right applications without adjustable suspension, this harness is built to restore reliable signal transfer between the antilock brake speed sensor and the vehicle wire harness.

Key Features

• Fits 2011-2016 Cadillac SRX, front right, without adjustable suspension
• OE-quality connectors and terminals for accurate electrical connection
• Square and rectangle connector shapes for application-specific fitment
• Female connector design with blade terminals
• Protective sleeve helps reduce wire chafing and short-circuit risk
• Glass-reinforced plastic resin housing resists heat and environmental exposure
• Includes grommets and wire clips for routing and mounting within the chassis

Detailed Description

Standard Ignition ALH182 is an antilock brake speed sensor harness engineered for direct replacement use on the front right side of the Cadillac SRX. The harness is built with OE-style connectors and terminals to help maintain a tight, weather-resistant electrical connection to the engine wire harness. Its molded construction and protective sleeve support durability in high-temperature and exposed underbody conditions. This part cross-references OSC 1728 for the same application.

Common Problems This Part Can Address

• Intermittent ABS warning light caused by a damaged wheel speed sensor harness
• Signal loss from cracked, corroded, or loose wiring connections
• Chafed insulation from harness routing near chassis components
• Moisture intrusion at worn connector terminals
• Improper harness positioning after prior repair or collision damage

Installation Notes and Tips

Verify the vehicle is a 2011-2016 Cadillac SRX front right application without adjustable suspension before installation. Inspect the connector ends, routing path, and mounting points before transferring the new harness into place. Confirm the harness is clipped and seated correctly so it does not contact moving suspension or sharp chassis edges.

Quality Assurance

Standard Ignition ALH182 is built with OE-quality connector and terminal materials, plus a glass-reinforced plastic resin body for heat and environmental resistance. The harness construction is intended to support dependable electrical continuity and long-term routing stability in the brake system area.