Standard Ignition ALH185 ABS Wheel Speed Sensor Wiring Harness - Front Left

ABS Wheel Speed Sensor Harness for Front Left Service

Standard Ignition ALH185 is an ABS wheel speed sensor wiring harness built for direct service on select Chevrolet Equinox and Pontiac Torrent front left applications. It uses OE-quality connectors and terminals to support a secure, water-tight connection at the engine wire harness while helping restore reliable wheel speed signal transfer.

Key Features

• OE-quality connectors and terminals for accurate electrical connection
• Female connector design with oval connector shape
• Male blade plug terminals for the harness interface
• Protective sleeve helps guard wires against chafing and short circuits
• Glass-reinforced plastic resin construction resists heat and environmental exposure
• Includes grommets and wire clips for proper mounting and routing within the chassis

Detailed Description

This Standard Ignition ABS wheel speed sensor wiring harness is engineered for front left service on 2005-2006 Chevrolet Equinox and 2006 Pontiac Torrent models. The ALH185 is built to restore the electrical path between the wheel speed sensor and the vehicle harness, using connectors and terminals that support a tight, sealed connection in demanding underbody conditions. Its routing aids and protective sleeve help maintain a clean installation path and reduce wear from vibration and movement.

This part cross-references Dorman - TECHoice 645-746 for the same application.

What It Helps Fix

• ABS warning light caused by a damaged wheel speed sensor harness
• Intermittent wheel speed signal loss at the front left corner
• Corrosion or moisture intrusion at the connector interface
• Wire chafing that can lead to open circuits or shorts
• Poor harness routing after prior brake or suspension repair

Installation Notes and Tips

Verify front left fitment before installation on your Chevrolet Equinox or Pontiac Torrent. Inspect the sensor connector, chassis routing points, and nearby clips or grommets for wear before transferring the harness into place. Confirm the connector orientation and secure the harness so it follows the original routing path away from moving suspension components and heat sources.

Quality Assurance

Standard Ignition builds this harness with OE-quality connector and terminal materials, glass-reinforced plastic resin, and a protective sleeve to support dependable service in harsh undercar conditions. Part number ALH185 is intended for direct replacement use on the listed applications.