Standard Ignition ALH41 ABS Wheel Speed Sensor Wiring Harness - Front Right

ABS Wheel Speed Sensor Harness for Front Right Service

Standard Ignition ALH41 is a direct replacement ABS wheel speed sensor wiring harness for front right applications on select Pontiac Montana and Oldsmobile Silhouette models. It is built for a secure electrical connection and proper routing in the chassis, helping restore reliable sensor signal transfer after harness damage or connector wear.

Key Features

• OE-style connectors and terminals for a water-tight connection to the engine wire harness
• Includes grommets and wire clips for proper mounting and routing within the chassis
• Protective sleeve helps prevent wire chafing and short circuits
• Glass reinforced plastic resin construction for heat and environmental resistance
• Direct replacement design for ABS wheel speed sensor harness service
• Connector configuration: oval, female and male
• Terminal type: blade and pin

Detailed Description

Standard Ignition ALH41 is an ABS wheel speed sensor wiring harness made for front right service on 2001-2005 Pontiac Montana and 2001-2004 Oldsmobile Silhouette. The harness uses OE connectors and terminals to support a secure electrical interface, while the included grommets and wire clips help maintain factory-style routing along the chassis. A protective sleeve adds abrasion resistance, and the glass reinforced plastic resin construction is built to handle heat and underbody exposure. This part cross-references Dorman OE Solutions 970-044 for the same application.

What It Helps Fix

• Intermittent ABS warning light caused by damaged wheel speed sensor wiring
• Open or shorted sensor circuit from chafed insulation
• Corrosion or poor contact at the connector ends
• Routing issues after a broken or missing harness retainer
• Signal loss at the front right ABS wheel speed sensor on Pontiac Montana or Oldsmobile Silhouette

Installation Notes and Tips

Verify the front right location before installation and compare the connector shape, terminal style, and harness length to the original part. Route the harness using the supplied clips and grommets so it follows the chassis path without tension or rubbing. After installation, clear ABS fault codes and confirm proper sensor operation with a scan tool.

Quality Assurance

Standard Ignition builds this harness as a direct replacement part with OE-style connectors, terminals, and protective materials to support dependable electrical performance in demanding underbody conditions.