Standard Ignition ALH89 ABS Wheel Speed Sensor Wiring Harness - Front

OE-Style ABS Wheel Speed Sensor Harness

Standard Ignition ALH89 is an ABS wheel speed sensor wiring harness built for front applications on select Ford vehicles. It uses OE-quality connectors and terminals to support a secure, water-tight connection at the engine wire harness and helps restore reliable signal transfer for the antilock brake system.

Compatible with 2013-2018 Ford C-Max, front; 2015-2018 Ford Focus, front; and 2014-2018 Ford Transit Connect, front. This Standard Ignition ALH89 harness is a direct-fit service part for common front ABS sensor wiring repairs.

Key Features

• Female connector design with oval connector shape
• Male pin terminals for proper electrical contact
• OE-quality connectors and terminals for a secure connection
• Glass-reinforced plastic resin housing for heat and environmental resistance
• Protective sleeve helps reduce wire chafing and short circuits
• Includes grommets and wire clips for mounting and routing within the chassis

Detailed Description

Standard Ignition ALH89 is engineered as an antilock brake speed sensor harness for front-mounted applications. The harness construction focuses on stable routing, sealed connections, and protection from heat, moisture, and abrasion. For Ford C-Max, Ford Focus, and Ford Transit Connect front ABS sensor wiring repairs, this part supports a clean replacement where damaged wiring, connector wear, or routing issues have affected sensor performance. This part cross-references BV6Z2B325A for the same application.

Common Repair Uses

• ABS warning light caused by damaged front wheel speed sensor wiring
• Intermittent wheel speed signal loss from worn connectors or terminals
• Chafed or broken harness insulation near the chassis routing path
• Moisture intrusion at the connector interface
• Poor sensor communication after harness damage on Ford C-Max, Ford Focus, or Ford Transit Connect

Installation Notes and Tips

Inspect the connector ends, clips, and routing path before installation. Confirm the harness follows the original mounting points so the wire sleeve and grommets can protect the cable from movement and abrasion. Verify the connector shape and terminal style match the original front ABS sensor harness before final assembly.

Quality Assurance

Standard Ignition uses OE-quality connector and terminal construction, along with protective materials selected to withstand heat and environmental exposure. The harness is built to support accurate electrical connection and durable routing in the vehicle chassis.