Standard Ignition ALH91 ABS Wheel Speed Sensor Wiring Harness - Rear

Rear ABS Wheel Speed Sensor Harness for Escape

Standard Ignition ALH91 is an ABS wheel speed sensor wiring harness built for rear applications on the 2014-2016 Ford Escape. It uses OE-quality connectors and terminals to support a secure, water-tight connection at the engine wire harness and helps restore reliable sensor signal transfer.

Key Features

• Fits 2014-2016 Ford Escape, rear
• OE-quality connectors and terminals for a secure electrical connection
• Female connector and female terminal design
• Oval connector shape for application-specific fitment
• Glass-reinforced plastic resin housing for heat and environmental resistance
• Protective sleeve helps reduce wire chafing and short-circuit risk
• Includes grommets and wire clips for proper chassis routing and mounting

Detailed Description

Standard Ignition ALH91 is an antilock brake speed sensor harness made for rear placement on the Ford Escape. The harness is built with two female connectors and two female alligator terminals, and its OE-style construction supports accurate signal transfer between the ABS wheel speed sensor and the vehicle wiring. Standard Ignition ALH91 is a direct-fit repair option for 2014, 2015, and 2016 Ford Escape rear ABS wiring service.

This part cross-references Ford OE-style numbers such as DV6Z2C055B and 536092 for the same application.

Common Problems It Can Help Solve

• Intermittent ABS warning light from a damaged rear wheel speed sensor harness
• Signal loss caused by cracked insulation or worn terminals
• Electrical faults from moisture intrusion at the connector
• Chafed wiring from poor routing along the chassis
• Brake system fault codes related to rear sensor circuit issues

Installation Notes and Tips

Verify rear harness routing before installation and secure the harness with the supplied grommets and wire clips as intended by the vehicle layout. Inspect the mating connector, sensor lead, and nearby wiring for corrosion, abrasion, or heat damage before connecting the replacement harness. Confirm the connector shape and terminal style match the original part before final assembly.

Quality Assurance

Standard Ignition builds this harness with OE-quality connectors and terminals, glass-reinforced plastic resin, and a protective sleeve to support durable service in underbody conditions. The design focuses on accurate connection quality, routing stability, and resistance to heat and environmental exposure.