Standard Ignition ALH92 ABS Wheel Speed Sensor Wiring Harness - Rear Left

ABS Wheel Speed Sensor Harness for Ford C-Max

Standard Ignition ALH92 is an ABS wheel speed sensor wiring harness for the rear left position on 2014-2018 Ford C-Max models. It is built with OE-quality connectors and terminals to support a secure, water-tight connection at the engine wire harness and chassis routing points.

Key Features

• Fits 2014-2018 Ford C-Max, rear left
• OE-quality female connectors and female blade terminals
• Oval and square connector shapes for the specified application
• Glass-reinforced plastic resin housing for heat and environmental resistance
• Protective sleeve helps reduce wire chafing and short-circuit risk
• Includes grommets and wire clips on the harness for proper mounting and routing

Detailed Description

Standard Ignition ALH92 is an antilock brake speed sensor harness made for the rear left wheel position on Ford C-Max vehicles from 2014 through 2018. The harness uses OE-style connectors and terminals to maintain a reliable electrical connection between the wheel speed sensor and the vehicle wiring. Its molded construction and protective sleeve help the harness withstand heat, moisture, and underbody exposure while supporting clean routing through the chassis. This part cross-references Ford OE number AV6Z2C055C for the same application.

Common Problems This Harness Can Address

• Intermittent ABS warning light from a damaged wheel speed sensor circuit
• Open or shorted wiring caused by chafing near the wheel area
• Corrosion or moisture intrusion at the connector interface
• Poor sensor signal caused by loose or worn terminals
• Routing issues after harness damage or previous repair work

Installation Notes and Tips

Verify the rear left position and compare the connector shape, terminal style, and harness routing before installation. Inspect the wheel speed sensor, connector pins, and nearby wiring for corrosion, abrasion, or broken clips that could affect the repair. Confirm the harness is secured with the supplied grommets and wire clips so it follows the original chassis path and stays clear of moving suspension components.

Quality Assurance

Standard Ignition uses OE-quality connectors and terminals, along with glass-reinforced plastic resin and a protective sleeve, to support dependable electrical performance in demanding underbody conditions. Standard Ignition ALH92 is built for the specified Ford C-Max application and is intended to restore proper ABS wheel speed sensor circuit integrity.