Standard Ignition ALH94 ABS Wheel Speed Sensor Wiring Harness - Rear Left

OE-Style ABS Harness for Rear Left Focus

Standard Ignition ALH94 is an ABS wheel speed sensor wiring harness built for the rear left position on 2016-2018 Ford Focus models. It uses OE-quality connectors and terminals to support a secure, water-tight connection at the engine wire harness and includes routing features for a cleaner, more accurate repair.

Key Features

• Fits 2016-2018 Ford Focus, rear left
• Female connector and female terminal design
• Oval connector shape for application-specific fitment
• High-temperature, glass-reinforced plastic resin housing
• Protective sleeve helps reduce wire chafing and short circuits
• Includes grommets and wire clips for proper mounting and routing
• Standard Ignition ALH94 for direct replacement service

Detailed Description

This ABS wheel speed sensor wiring harness is built to restore the electrical path between the wheel speed sensor and the vehicle harness on the rear left side of a Ford Focus. Standard Ignition ALH94 is engineered with OE-style connectors and terminals to help maintain a tight, sealed connection, while the harness construction supports durability in heat, moisture, and road exposure. This part cross-references Ford F1EZ2C055G for the same application.

For buyers searching for a rear left ABS sensor harness for 2016, 2017, or 2018 Ford Focus models, ALH94 provides the correct connector style and routing features needed for a clean replacement. The protective sleeve and mounting aids help keep the harness positioned properly within the chassis.

Common Repair Symptoms

• ABS warning light caused by an open or damaged wheel speed sensor circuit
• Intermittent wheel speed signal from a broken or corroded harness
• Chafed wiring near the chassis or suspension area
• Water intrusion at the connector causing poor electrical contact
• Fault codes related to the rear left ABS wheel speed sensor circuit

Installation Notes and Tips

Verify the rear left location and connector shape before installation. Inspect the sensor connector, harness routing, and nearby clips or grommets for wear before connecting the new harness. Confirm that the harness is seated away from moving suspension components and sharp edges to help prevent repeat damage.

Quality Assurance

Standard Ignition builds this harness with OE-quality connectors and terminals, glass-reinforced plastic resin, and a protective sleeve to support reliable electrical contact and long-term durability in demanding underbody conditions.