Standard Ignition ALS1946 ABS Wheel Speed Sensor Wiring Harness - Front Left

ABS Wheel Speed Sensor Harness for Genesis Coupe

Standard Ignition ALS1946 is an ABS wheel speed sensor wiring harness for the front left position on select 2010-2016 Hyundai Genesis Coupe models. It provides the electrical connection between the wheel speed sensor and the vehicle harness, supporting accurate ABS signal transfer at the spindle.

Key Features

• ABS wheel speed sensor wiring harness for brake system service
• Fits 2010-2016 Hyundai Genesis Coupe, front left
• 38-inch harness length for routing at the spindle
• 2-terminal design with a rectangular, 1-connector layout
• Male connector with female blade terminals
• Bolt-mount installation with 2 bolt holes
• Standard Ignition ALS1946 replacement part number

Detailed Description

Standard Ignition ALS1946 is built as a direct-style ABS wheel speed sensor wiring harness for the front left spindle location on the Hyundai Genesis Coupe. The harness uses a rectangular connector with 2 terminals, a male connector interface, and female blade terminals to maintain the sensor circuit connection. With a 38-inch length, it is sized for routing along the suspension and spindle area where the original harness is mounted. Standard Ignition ALS1946 is also referenced by interchange part numbers for the same application, including 1P3832 and ABS2039.

Compatible With 2010-2016 Hyundai Genesis Coupe front left ABS wheel speed sensor wiring harness applications, this part is a practical replacement when the original harness connection at the wheel end is damaged or no longer maintaining a stable signal. Standard Ignition ALS1946 is a fitment-specific service part for Genesis Coupe brake system wiring repair.

Common Issues This Part Can Address

• Broken or frayed ABS sensor wiring at the spindle
• Intermittent wheel speed sensor signal loss
• Corrosion or damage at the connector terminals
• ABS warning light caused by harness failure
• Routing damage from suspension movement or road debris

Installation Notes and Tips

• Verify front left fitment before ordering for your Hyundai Genesis Coupe.
• Inspect the sensor connector, terminal condition, and mounting points before installation.
• Confirm the 2-bolt mounting location at the spindle matches the original harness.
• Route the harness away from moving suspension components and sharp edges.
• Check the ABS system for stored codes after installation and clear them as needed.

Quality Assurance

Standard Ignition supplies replacement electrical and ignition components for service applications, and ALS1946 follows the specified connector, terminal, mounting, and length details for the listed vehicle fitment.