Standard Ignition APS628 Accelerator Pedal Sensor

Accelerator Pedal Sensor for Nissan and INFINITI

Standard Ignition APS628 is an accelerator pedal sensor built for direct replacement on select Nissan and INFINITI applications. It uses a rectangular female plug-in connector with 6 male terminals for a straightforward electrical interface.

• Accelerator pedal sensor for electronic throttle input
• Rectangular, female connector with plug-in design
• 6 male terminals for the specified vehicle harness connection
• Direct-fit replacement for select Nissan Altima and INFINITI QX50 applications
• Standard Ignition APS628 for pedal position signal restoration

Fitment Details

Fits 2019-2025 Nissan Altima, N/A.

Fits 2019 INFINITI QX50, N/A.

This part cross-references 2-80528 and 180026CA0A for the same application.

How This Sensor Is Used

• Restores accelerator pedal position signal accuracy
• Addresses throttle response concerns caused by sensor wear
• Helps correct intermittent pedal input or signal dropouts
• Supports proper electronic throttle control operation
• Replaces a damaged or failing pedal sensor on the listed vehicles

Installation Notes and Tips

Verify connector style, terminal count, and vehicle fitment before installation. Inspect the pedal assembly and harness connector for corrosion, bent terminals, or damage that could affect sensor performance. After installation, clear any stored fault codes and confirm throttle response with a scan tool if required by the vehicle.

Quality Assurance

Standard Ignition supplies replacement electrical components for service applications, and APS628 is built to match the listed connector and terminal configuration for the specified vehicles.