Standard Ignition BTL111 Center High Mount Stop Light

Center High Mount Stop Light for Ford Escape

Standard Ignition BTL111 is a direct-fit center high mount stop light replacement for select 2013-2018 Ford Escape models. It is built to match OE fit, form, and function, with attention to the third brake light gasket area where water intrusion can lead to lighting failure.

Key Features

• Direct-fit replacement for the center high mount stop light assembly
• Designed for 2013-2018 Ford Escape applications
• Female connector with a square connector shape
• 2-pin terminal design with male terminals
• Helps replace dry-rotted OE third brake light gaskets
• Built to reduce water intrusion at the lamp sealing area
• Standard Ignition BTL111 for straightforward identification

Detailed Description

Standard Ignition BTL111 is a center high mount stop light made for Ford Escape vehicles from 2013 through 2018. This part is intended to restore proper rear brake light function while matching the original mounting and electrical interface. The connector design uses a female connector with a square shape and a 2-pin male terminal layout, which supports OE-style electrical connection at the rear of the vehicle. For shoppers searching for a 2013-2018 Ford Escape third brake light replacement, BTL111 provides a focused solution for the factory stop lamp location.

This part cross-references Dorman - OE Solutions 923-292 for the same application.

Common Issues It May Address

• Brake light failure caused by moisture intrusion at the third brake light area
• Cracked or dry-rotted OE gasket material around the center high mount stop light
• Intermittent rear stop lamp operation from a damaged connector interface
• Water leaks near the upper rear liftgate lamp opening
• Need for a direct-fit Ford Escape center brake light replacement

Installation Notes and Tips

Verify connector shape, terminal style, and vehicle year before installation. This part is listed for 2013-2018 Ford Escape models, so confirm the original lamp configuration matches the vehicle before replacing the assembly. Inspect the mounting surface and surrounding seal area for residue, corrosion, or moisture before installing the new unit.

Quality Assurance

Standard Ignition states that this replacement is manufactured with complete quality control throughout the production process. The design focus is proper fit, form, and function, with sealing support intended to help limit water intrusion at the third brake light opening.