Standard Ignition DR-329 Distributor Rotor

Distributor Rotor for Reliable Ignition Contact

Standard Ignition DR-329 is a distributor rotor built for stable spark transfer and long service life. It uses a high dielectric-strength engineering polymer body, a solid brass contact segment, and a stainless steel spring to maintain consistent contact inside the distributor cap.

Fits 2006-2011 Honda Civic, front right. Fits 2006-2011 Honda Civic, front left. Fits 2006-2011 Toyota Corolla, front right. Fits 2006-2011 Toyota Corolla, front left.

Key Features

• High dielectric-strength polymer helps prevent arcing and electrical breakdown
• Solid brass segment resists pitting and erosion for extended service life
• Shaft retention clips support proper distributor shaft fit
• Stainless steel spring maintains positive contact with the distributor cap brush
• Corrosion-resistant spring construction supports dependable operation
• Part number DR-329 for direct catalog lookup and service matching

Detailed Description

This Standard Ignition distributor rotor is engineered for vehicles that rely on a conventional distributor ignition system. The brass contact surface promotes steady current transfer, while the polymer housing helps isolate the rotor from electrical breakdown under operating heat and load. For Honda Civic and Toyota Corolla service work, DR-329 provides a straightforward replacement option when the original rotor shows wear, carbon tracking, or contact damage. This part cross-references Cardone Reman 18-5405 for the same application.

Common Issues It Can Address

• Engine misfire caused by worn rotor contact surfaces
• Hard starting from weak spark transfer inside the distributor
• Intermittent ignition performance from arcing or carbon tracking
• Rough idle related to pitted or eroded rotor terminals
• Corrosion-related contact loss at the distributor cap brush

Installation Notes and Tips

Inspect the distributor cap, cap brush, and rotor shaft area before installation. Replace the rotor if the brass segment is burned, cracked, or heavily worn, and verify that the shaft retention clips seat correctly during assembly. Confirm the rotor orientation matches the distributor shaft before closing the cap.

Quality Assurance

Standard Ignition builds this rotor with materials selected for electrical insulation, contact durability, and corrosion resistance. The DR-329 is a service replacement part intended to restore consistent distributor operation when the original rotor is no longer performing as specified.