Standard Ignition DS-1362 Headlight Switch

Headlight Switch for Ford F-250 and F-350

Standard Ignition DS-1362 is a 12-volt headlight switch built for direct, snap-fit replacement in select Ford trucks. It uses copper alloy conductors for strong electrical conductivity and low resistive loss, with a black plastic finish and a 2-connector, 10-blade terminal layout.

Compatible With 2001-2004 Ford F-250, 2001-2004 Ford F-250 Super Duty, 2001-2004 Ford F-350, and 2001-2004 Ford F-350 Super Duty in configurations without fog lights and, on listed applications, without automatic headlight control.

• Direct, snap-fit attachment method for OE-style replacement
• Headlight function switch for 12-volt electrical systems
• Female 2-connector design with rectangular connector shape
• Male blade terminals, 10-terminal layout
• Black plastic finish for a factory-style appearance
• Copper alloy conductors for low-resistance electrical transfer

Detailed Product Overview

This Standard Ignition headlight switch, part number DS-1362, is engineered for service replacement where reliable headlight control is required. It is built with robust materials and fully tested for mechanical and electrical switching performance before release. For Ford F-250 and Ford F-350 trucks, DS-1362 supports a clean replacement path when the original switch has worn contacts, intermittent operation, or failed illumination control.

This part cross-references 1S2672 and SW2866 for the same application.

Common Problems This Switch Can Address

• Headlights that do not turn on or off consistently
• Intermittent switch response when rotating or pulling the control
• Electrical resistance caused by worn internal contacts
• Loss of normal headlight control on select Ford F-250 and F-350 trucks
• Replacement needs after switch housing or terminal wear

Installation Notes and Tips

Verify the vehicle is a 12-volt application and confirm the truck is equipped without fog lights before ordering. Some listed fitments also require no automatic headlight control. Match the connector style, terminal count, and switch function to the original unit before installation. Always inspect the harness connector and terminals for heat damage, corrosion, or looseness before connecting the new switch.

Quality Assurance

Standard Ignition builds this switch with copper alloy conductors and tests each unit for both mechanical action and electrical switching performance. The design reflects long-term development focused on technician requirements and dependable service replacement.