Standard Ignition EGV1260 EGR Valve

Electronic EGR Valve for Toyota and Lexus

Standard Ignition EGV1260 is an electronic exhaust gas recirculation (EGR) valve for select Toyota and Lexus applications. It is built with a rectangular female connector, bolt-mount design, and six blade terminals for direct replacement use on supported vehicles.

Compatible With 2012-2016 Toyota Camry, 2013-2016 Toyota Avalon, 2013-2018 Lexus ES300h, 2015-2019 Lexus NX300h, and 2016-2018 Toyota RAV4. Standard Ignition EGV1260 is a fitment-based replacement for drivers searching for an EGR valve for Toyota Camry, Lexus ES300h, or Toyota RAV4 emissions repair.

Key Features

• Electronic EGR valve for emission control service
• Bolt-mount installation with six bolt holes
• Rectangular female connector with one electrical connection
• Six blade terminals for the vehicle harness interface
• Two hose connectors and two vacuum ports
• Direct-fit replacement for supported Toyota and Lexus models

Detailed Description

The Standard Ignition EGV1260 exhaust gas recirculation valve regulates exhaust flow back into the intake stream to support emissions system operation on the listed Toyota and Lexus vehicles. Its electronic design is intended for modern engine management systems that rely on precise valve control rather than a purely mechanical or vacuum-only setup. This part number, EGV1260, is a practical choice when replacing a worn or malfunctioning EGR valve on a Toyota Camry, Lexus ES300h, or Toyota RAV4 application.

This part cross-references 2-26933 and 2562036030 for the same application.

Common Problems It Can Address

• Check engine light related to EGR flow faults
• Rough idle caused by restricted exhaust recirculation
• Driveability issues from a sticking or failing EGR valve
• Emissions test failure tied to EGR system performance
• Reduced engine efficiency from improper exhaust gas routing

Installation Notes and Tips

• Verify connector style, bolt pattern, and vacuum port layout before installation.
• Inspect the mating surfaces and replace any damaged seals or gaskets as needed, since gasket or seal is not included.
• Confirm the intake and EGR passages are clean to prevent repeat failure after replacement.
• Use the vehicle service procedure for torque and electrical checks during installation.

Quality Assurance

Standard Ignition supplies replacement emission control components for service applications, and EGV1260 is cataloged for the listed Toyota and Lexus fitments. Confirm vehicle year, make, and model before ordering to ensure the correct EGR valve for your application.