Standard Ignition EGV1313 Exhaust Gas Recirculation (EGR) Valve

OE Replacement EGR Valve for Ford Applications

Standard Ignition EGV1313 is an electronic exhaust gas recirculation valve built as an OE replacement for select Ford trucks and SUVs. It is used to regulate exhaust gas flow back into the intake stream, helping maintain emissions control performance on supported applications.

• Electronic EGR valve with 5-pin male terminals
• Bolt-mount design with 3 bolt holes
• Includes 1 hose connector and 1 vacuum port
• OE replacement part for direct-fit service on listed vehicles
• Standard Ignition EGV1313 for emissions system repair

Vehicle Fitment

• Fits 2025 Ford Explorer, N/A
• Fits 2020-2023 Ford Explorer, N/A
• Fits 2018-2023 Ford F-150, N/A
• Fits 2020-2021 Ford Transit-150, N/A
• Fits 2020-2021 Ford Transit-250, N/A
• Fits 2020-2021 Ford Transit-350, N/A
• Fits 2020-2021 Ford Transit-350 HD, N/A

Detailed Description

Standard Ignition EGV1313 is an electronic EGR valve for emissions control service on Ford Explorer, Ford F-150, and Transit van platforms listed above. As an OE replacement, it matches the original mounting style with a bolt-mount layout, 3 bolt holes, a single hose connector, and a 5-terminal male pin connection for proper electrical interface. This part number, EGV1313, is also referenced for the same application under Standard Ignition EGV1313.

This part cross-references Monroe Shocks & Struts (e.g., 2-36042, CX2567) for the same application.

Common Repair Uses

• Restoring EGR flow control when the valve is sticking or not responding
• Addressing emissions-related fault codes tied to EGR performance
• Correcting rough idle or drivability issues linked to exhaust gas recirculation faults
• Replacing a worn OE-style EGR valve on Ford Explorer, Ford F-150, or Transit models
• Repairing vacuum or electrical connection problems at the EGR valve assembly

Installation Notes

Verify connector style, bolt pattern, and hose/vacuum port layout before installation. Mounting hardware and gasket or seal are not included, so reuse or source the required sealing components separately. Confirm the vehicle’s emissions system configuration and clear diagnostic trouble codes after installation if needed.

Quality Assurance

Standard Ignition EGV1313 is an OE replacement emissions component built to match the original part’s electronic control and mounting configuration for the listed Ford applications.