Standard Ignition EWP102 Electric Engine Water Pump

Electric Water Pump for BMW Cooling Systems

Standard Ignition EWP102 is an electric engine water pump built for select BMW cooling system applications. It features a female connector, a single connector interface, male blade terminals, and included gaskets for a direct replacement setup.

Key Features

• Electric engine water pump for BMW cooling system service
• Female connector with 1 connector interface
• 4 male blade terminals for electrical connection
• Gaskets included for sealing at installation
• Cross-references Standard Ignition EWP702 and WPE102 for the same application

Detailed Description

This Standard Ignition EWP102 electric engine water pump is engineered for vehicles that use an electrically driven coolant circulation system rather than a belt-driven pump. It fits 2011-2012 BMW X3 and 2011 BMW 528i applications, making it a direct-fit option for BMW cooling system repair on these model years. The connector and terminal layout should be matched to the original unit before installation to confirm proper electrical connection and fit.

Use EWP102 when replacing a failed electric water pump on BMW X3 or BMW 528i models with the listed fitment. The included gaskets support proper sealing at the pump interface, helping restore coolant flow through the engine cooling circuit.

What It Helps Fix

• Coolant circulation loss from a failed electric water pump
• Engine overheating caused by pump motor or internal pump failure
• Coolant leaks at the pump sealing surface
• Warning lights or fault codes related to cooling system performance
• Reduced heater output caused by poor coolant flow

Installation Notes and Tips

Verify connector style, terminal count, and mounting location against the original pump before installation. Drain the cooling system as needed, inspect adjacent hoses and seals, and refill with the correct BMW-approved coolant after installation. Bleed the system according to the vehicle service procedure to remove trapped air and restore normal circulation.

Quality Assurance

Standard Ignition supplies replacement electrical and engine management components for service applications. EWP102 is built to match the listed BMW fitment and cross-references OE and aftermarket part numbers for the same application.