Standard Ignition FICM3 Fuel Injector Control Module

Remanufactured Injector Control Module

The Standard Ignition FICM3 is a remanufactured fuel injector control module built for Ford diesel applications that need stable injector control and reliable power delivery. It includes a new FICM power board and is pre-programmed for direct replacement service.

Compatible With 2004-2010 Ford E-350 Super Duty, 2005-2007 Ford F-250 Super Duty, 2005-2007 Ford F-350 Super Duty, and 2004-2005 Ford E-350 Club Wagon.

Key Features

• Remanufactured injector control module for air and fuel delivery systems
• Includes a new FICM power board
• Pre-programmed for installation-ready service
• Upgraded 100% new power supply to address heat-related failure points
• Logic module uses new components where needed
• Gold-plated power supply contacts improve energy transfer
• Built-in load dump protection helps reduce high-voltage interference
• Power supply components are epoxied in place to resist vibration-related issues
• Male blade terminals with 16 + 16 + 22 terminal layout

Product Details

Standard Ignition FICM3 is engineered as a remanufactured replacement for injector control modules that fail from heat, vibration, or electrical stress. The upgraded power supply uses new electronics and protective design features to help maintain stable operation, while the logic section receives new components wherever required. This part cross-references Dorman HELP 921-124 for the same application.

Common Problems It Can Address

• Hard starting caused by injector control module failure
• Rough running or intermittent injector operation
• Loss of injector command from heat-damaged electronics
• Electrical instability from vibration-related internal damage
• High-voltage interference affecting module performance

Installation Notes

Verify the vehicle application and connector style before installation. This module is pre-programmed, which helps reduce setup time, but the replacement should still be matched to the correct Ford Super Duty or E-350 application. Inspect related wiring, connectors, and power supply circuits for heat damage or corrosion before installing the new module.

Quality Assurance

This remanufactured module is assembled at a certified facility in the U.S.A. The upgraded power supply design, new components where needed, and vibration-resistant assembly methods are used to improve consistency in service compared with failed OE or aftermarket units.