Standard Ignition FLS-191 Washer Fluid Level Sensor - Front

Washer Fluid Level Sensor for Toyota and Lexus

Standard Ignition FLS-191 is a washer fluid level sensor built for front-mounted applications on a wide range of Toyota and Lexus vehicles. It uses a female plug-in connector with two male blade terminals for direct electrical connection in the reservoir circuit.

Key Features

• Washer fluid level sensor for front reservoir applications
• Female connector with 1 plug-in connection
• 2 male blade terminals for straightforward electrical interface
• Sensor-only contents for replacement of the failed level sensing component
• Direct-fit coverage for many Toyota Camry, RAV4, Sienna, Tacoma, and Tundra applications

Detailed Description

Standard Ignition FLS-191 is a replacement washer fluid level sensor for vehicles that monitor windshield washer reservoir fluid status. It is listed for front position applications across Toyota Camry, RAV4, Highlander, Sienna, Tacoma, Tundra, Avalon, Venza, Sequoia, and select Lexus ES, RX, and RX450h models. This part number also cross-references Standard Ignition FLS765 for the same application.

Use FLS-191 when the washer warning system is not reading fluid level correctly or when the original sensor has failed at the reservoir. The connector design and blade-terminal layout support OE-style electrical connection in the washer system.

Common Issues This Part Can Address

• Washer fluid warning light stays on with a full reservoir
• Washer fluid level warning does not illuminate when fluid is low
• Intermittent washer reservoir level readings
• Failed sensor signal at the front washer reservoir
• Corrosion or wear at the original level sensor connection

Installation Notes and Tips

Verify the connector style, terminal layout, and reservoir location before installation. Confirm vehicle fitment by year, make, model, and position, especially on Toyota Camry, Toyota RAV4, Toyota Sienna, Toyota Tacoma, and Lexus RX applications. Inspect the washer reservoir opening and electrical connector for damage or contamination before installing the new sensor.

Quality Assurance

Standard Ignition supplies replacement electrical components for import and domestic applications, and FLS-191 is built to match the listed connector and terminal configuration for the specified vehicles.