Standard Ignition GB-375 Distributor Rotor

Distributor Rotor for Ignition Service

Standard Ignition GB-375 is a distributor rotor built for ignition system service where a direct, push-on replacement is needed. It uses a plastic rotor body with a brass contact and a red finish for straightforward identification during maintenance.

Key Features

• Push-on mount type for distributor applications
• Brass contact material for consistent spark transfer
• Plastic rotor construction
• Red color/finish for easy visual identification
• Distributor rotor only

Product Details

The Standard Ignition GB-375 distributor rotor is a replacement ignition component used inside the distributor to route secondary ignition voltage to the correct terminal. Its brass contact and plastic housing support reliable electrical transfer in service applications. This part number GB-375 is also referenced in ignition parts catalogs for cross-checking during repair planning. This part cross-references Standard Ignition GB-375 for the same application.

Common Repair Uses

• Misfire caused by worn rotor contact
• Hard starting related to distributor wear
• Intermittent ignition performance from carbon tracking or contact wear
• Rough idle tied to distributor service issues
• Routine ignition tune-up replacement

Installation Notes

Verify distributor style and rotor mount type before installation. Inspect the distributor cap, terminals, and related ignition components for wear or corrosion at the same time. Confirm the rotor seats fully on the distributor shaft and matches the original push-on design. For vehicle-specific service, check the application listing for the exact make and model before ordering GB-375.

Quality Assurance

Standard Ignition is a long-established ignition parts brand with a broad catalog of replacement components for service and maintenance work. GB-375 is built as a direct replacement distributor rotor for ignition system repair.