Standard Ignition HLS-1420 Headlight Switch

Headlight Switch for Chevrolet Traverse

The Standard Ignition HLS-1420 is a direct-fit headlight switch built for 12-volt electrical systems and everyday service demands. It is engineered with copper alloy conductors for strong electrical flow and low resistance, and each unit is tested for both mechanical action and electrical switching performance.

Compatible with 2009-2017 Chevrolet Traverse models without fog lights, this headlight switch is a practical replacement for worn, intermittent, or nonresponsive lighting controls. The HLS-1420 is a direct, snap-fit design with a single rectangular female connector and 16 male pin terminals.

Key Features

• Direct, snap-fit attachment method for straightforward replacement
• Headlight function with 4 switch positions
• 12-volt electrical design
• 1 rectangular female connector
• 16 male pin terminals
• Copper alloy conductors for efficient electrical conductivity
• 100% tested for mechanical and electrical switching performance

Detailed Description

Standard Ignition HLS-1420 is a replacement headlight switch for Chevrolet Traverse applications from 2009 through 2017, excluding vehicles equipped with fog lights. It is built to restore reliable headlight control when the original switch shows signs of wear, such as inconsistent operation, loss of function, or poor electrical contact. The HLS-1420 part number is also a useful reference when verifying the correct replacement for this application.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Solve

• Headlights that do not switch on or off consistently
• Intermittent lighting control from a worn internal switch
• Electrical resistance caused by degraded switch contacts
• Broken or unreliable dashboard headlight control operation
• Replacement needs for a failed Chevrolet Traverse headlight switch

Installation Notes and Tips

Verify the vehicle is a 2009-2017 Chevrolet Traverse without fog lights before ordering. Match the connector shape, terminal count, and switch positions to the original unit, and confirm the HLS-1420 part number against the existing switch when possible. Because this is a direct-fit electrical component, careful connector alignment and secure seating are important during installation.

Quality Assurance

Standard Ignition builds this switch with robust materials and copper alloy conductors, then tests each unit for mechanical and electrical switching performance. The design reflects long-term development focused on service-professional requirements.