Standard Ignition LX-355 Ignition Control Module

Ignition Control Module for GM V8 Applications

Standard Ignition LX-355 is an ignition control module built for distributor-mounted 12-volt systems that need reliable coil triggering and stable spark control. It is a direct-fit style replacement for select 1992-1993 Chevrolet Corvette, 1993 Chevrolet Camaro, and 1993 Pontiac Firebird applications.

Key Features

• Distributor-mounted ignition control module with bolt-on attachment method
• Female 1-connector design with 4 male blade terminals
• 12-volt electrical specification for the listed GM applications
• Double wire bonds for stronger internal connections and improved durability
• Copper slug heat sinks to help move heat away from the module
• High-temperature polymer housing to reduce moisture intrusion and vibration damage
• Durability tested through 500 thermal cycles from -40C to +125C

Detailed Description

Standard Ignition LX-355 is engineered for distributor ignition systems where consistent module performance matters. It is designed to respond quickly to a weak crankshaft position sensor signal and begin energizing the coils immediately, which supports dependable starting in cold-weather conditions. For drivers searching for a 1992-1993 Chevrolet Corvette ignition control module, a 1993 Chevrolet Camaro ignition control module, or a 1993 Pontiac Firebird ignition control module, LX-355 provides the OE-style electrical layout and mounting configuration needed for service replacement. This part cross-references Duralast (e.g., DR196) for the same application.

Common Problems This Part Can Help Address

• No-start or hard-start conditions related to ignition module failure
• Intermittent spark loss in distributor-based ignition systems
• Heat-related module breakdown from repeated thermal cycling
• Moisture intrusion and vibration-related electrical issues
• Delayed coil energizing during cold starts

Installation Notes and Tips

Verify the distributor-mounted connector style, 4-blade terminal layout, and 12-volt system requirements before installation. Clean the mounting surface and inspect related ignition components, including the crankshaft position sensor and coil connections, so the replacement module is not affected by an upstream fault. Confirm vehicle application by year and model before ordering the Standard Ignition LX-355.

Quality Assurance

Standard Ignition manufactures electronic ignition components with in-process quality control from component selection through final assembly. LX-355 is built with heat management and vibration-resistant construction features, and it has been thermal-cycle tested for durability across a wide temperature range.