Standard Ignition LX-655 Ignition Control Module

Ignition Control Module for Distributorless Systems

Standard Ignition LX-655 is an ignition control module for distributorless ignition systems. It is built for 12-volt operation and uses a bolt-on attachment method with 2 connectors, 6 terminals, and blade-style terminals for direct ignition mounting.

Compatible With Nissan D21, Pathfinder, 200SX, Maxima, Pulsar NX, Sentra, Pickup, and 720 applications listed below, this LX-655 ignition control module is a direct-fit service part for specific intake-side and clip-mounted configurations. Standard Ignition LX-655 is also cross-referenced to common replacement numbers for the same application.

• Ignition type: distributorless
• Direct ignition mounting location
• 12-volt electrical system
• Bolt-on attachment method
• 2 connectors with male/female connector gender
• 6 terminals with blade-style terminal type
• Coil not included
• Mounting hardware not included

Fitment Details

• Fits 1986 Nissan D21, intake side.
• Fits 1986-1989 Nissan D21.
• Fits 1986 Nissan 720.
• Fits 1986-1988 Nissan Sentra.
• Fits 1987-1988 Nissan Maxima.
• Fits 1987-1988 Nissan Pathfinder.
• Fits 1987 Nissan Pathfinder, w/ 7 3/4 Inch Wire; intake side.
• Fits 1987 Nissan Pathfinder, w/ 7 3/4 Inch Wire.
• Fits 1987 Nissan Pickup, w/ 7 3/4 Inch Wire; intake side.
• Fits 1987 Nissan Pulsar NX, Mitsubishi; From 3/87.
• Fits 1988 Nissan 200SX, intake side.
• Fits 1988 Nissan Pathfinder, intake side.
• Fits 1988 Nissan Pulsar NX.
• Fits 1988-1989 Nissan Pathfinder, w/ attaching clip.

What This Part Helps Address

• Intermittent or no-start conditions related to ignition module failure
• Misfire concerns caused by weak or inconsistent ignition triggering
• Rough idle from unstable distributorless ignition control
• Stalling or hesitation tied to ignition signal loss
• Check-engine or drivability issues traced to the ignition control module circuit

Installation Notes and Tips

Verify connector style, terminal count, and mounting location before installation. This LX-655 uses a direct ignition mounting location with a bolt-on design, so confirm the vehicle’s intake-side or attaching-clip configuration matches the listed fitment. No instructions, grease pack, coil, or mounting hardware are included.

Quality Assurance

Standard Ignition supplies OE-style replacement ignition components for service applications. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.