Standard Ignition MAS0226 Mass Air Flow Sensor

Mass Air Flow Sensor for Ford Mustang and Lincoln Continental

Standard Ignition MAS0226 is a mass air flow sensor built for direct replacement in select Ford and Lincoln applications. It uses a female rectangular connector with 4 male blade terminals and is supplied as sensor only for service on the air intake measurement circuit.

Key Features

• Mass air flow sensor for emission control and engine air measurement
• Sensor only configuration for replacement of the failed MAF unit
• Female rectangular connector with 4 male blade terminals
• Direct-fit service part for select 1998-2002 Lincoln Continental and 1999-2002 Ford Mustang applications
• Standard Ignition MAS0226 cross-references Delphi AF10121 and Spectra Premium MA300 for the same application

Detailed Description

Standard Ignition MAS0226 is a replacement mass air flow sensor used to measure incoming air so the engine control system can calculate fuel delivery accurately. It is listed for 1999-2002 Ford Mustang and 1998-2002 Lincoln Continental applications, making it a focused service part for owners searching for a Ford Mustang mass air flow sensor or a Lincoln Continental MAF sensor replacement. The MAS0226 part number is also useful when comparing interchange references during diagnosis or ordering.

This sensor-only design is intended for vehicles that need the airflow sensing element replaced without additional assemblies. The connector layout is a female rectangular plug with four male blade terminals, which helps match the original electrical interface on the supported vehicles.

What It Is Used For

• Correcting rough idle caused by inaccurate airflow readings
• Addressing hesitation or poor throttle response tied to MAF signal issues
• Resolving lean or rich fuel trim conditions related to a failing sensor
• Restoring drivability when the engine control module receives incorrect intake air data
• Replacing a damaged or contaminated mass air flow sensor on Ford Mustang or Lincoln Continental models

Installation Notes and Tips

Verify connector shape, terminal count, and sensor location before installation. Inspect the intake tract for dirt, oil contamination, or air leaks that can affect sensor readings after replacement. Clear diagnostic trouble codes and confirm airflow data with a scan tool after the repair.

Quality Assurance

Standard Ignition supplies service parts for emission control and engine management applications, and MAS0226 is built to match the listed connector and terminal configuration for the supported vehicles.