Standard Ignition PC1250 Engine Crankshaft Position Sensor

Engine Crankshaft Position Sensor for OE Replacement

Standard Ignition PC1250 is a new engine crankshaft position sensor built for accurate crankshaft signal input in ignition and engine management systems. It features a bolt-on attachment, one oval female plug-in connector, and a 3-terminal male mini-blade interface for a direct-style electrical connection.

For drivers searching for a crankshaft position sensor for Honda Civic, Toyota Camry, or similar engine management repairs, this Standard Ignition PC1250 part number is a practical OE-style replacement when the original sensor has failed or is reading inconsistently.

Key Features

• Brand: Standard Ignition
• Part number: PC1250
• Engine crankshaft position sensor
• New replacement sensor
• Bolt-on attachment method
• 1 oval female plug-in connector
• 3 male mini-blade terminals
• No mounting bracket included

Detailed Product Overview

The PC1250 is designed for vehicles that rely on a crankshaft position signal to coordinate ignition timing and engine control. Its connector layout and bolt-on mounting style support a straightforward replacement where the original sensor uses an oval plug-in connection and mini-blade terminals. Standard Ignition PC1250 is a fitment-specific sensor choice for repair work that calls for stable crankshaft position input and consistent engine operation.

This part cross-references 68237477AA and CPSA712 for the same application. If you are replacing a crankshaft position sensor on a Honda Civic, Toyota Camry, or another vehicle with the same connector and mounting configuration, verify the connector shape, terminal count, and mounting style before installation.

Common Symptoms This Part May Address

• Hard starting or extended crank time
• Intermittent stalling or sudden engine shutdown
• Check engine light related to crankshaft position signal faults
• Rough running caused by inconsistent engine speed input
• No-start condition tied to crankshaft sensor failure

Installation Notes and Tips

Confirm the connector is female, oval, and plug-in style before installation. Check that the mounting point uses a bolt-on sensor design and that the vehicle does not require a separate bracket, since this part does not include one. Inspect the harness connector, terminals, and nearby wiring for corrosion or damage before installing the new sensor. For best results, compare the original sensor shape and terminal layout to Standard Ignition PC1250 before final fitment.

Quality Assurance

Standard Ignition is a recognized aftermarket brand for ignition and engine management components. PC1250 is supplied as a new part and built to match the specified connector and mounting configuration for accurate replacement service.