Standard Ignition PG70 Fuel Injection Plenum Gasket

Fuel Injection Plenum Gasket for Toyota V8 Intake Sealing

Standard Ignition PG70 is a fuel injection plenum gasket for Toyota intake sealing applications. It is built with a plastic construction and includes an intake manifold gasket, with MFI seal type and 6-port coverage for the listed Toyota 4Runner and FJ Cruiser applications.

Key Features

• Fuel injection plenum gasket for intake manifold sealing
• Plastic material construction
• Includes intake manifold gasket
• MFI seal type
• 6-port design
• Standard Ignition PG70 replacement part

Detailed Description

Standard Ignition PG70 is a replacement fuel injection plenum gasket for 2003-2010 Toyota 4Runner and 2007-2010 Toyota FJ Cruiser applications. It is intended for intake sealing service where the plenum and manifold interface must maintain a proper seal to support consistent air and fuel delivery. This part cross-references Continental 50067 for the same application.

What This Part Helps Address

• Intake manifold vacuum leaks at the plenum sealing surface
• Rough idle caused by intake air leakage
• Loss of sealing integrity after intake service
• Air/fuel mixture issues related to a compromised plenum gasket
• Reassembly needs after intake manifold removal on Toyota 4Runner and FJ Cruiser models

Installation Notes and Tips

• Clean both mating surfaces before installation.
• Inspect the intake manifold and plenum for warpage, cracks, or carbon buildup.
• Replace the gasket during intake service whenever the original seal is disturbed.
• Verify correct alignment with the 6-port intake layout before tightening fasteners.
• Follow the vehicle service manual for torque sequence and final torque values.

Quality Assurance

Standard Ignition supplies replacement sealing components for air and fuel delivery service. PG70 is listed for direct application coverage on the specified Toyota models and is built to match the intake sealing requirements of those vehicles.