Standard Ignition PPS284 Parking Aid Sensor - Rear

Rear Park Assist Sensor for Kia Telluride

Standard Ignition PPS284 is a rear parking aid sensor for select 2020-2022 Kia Telluride models. It is built for vehicles equipped with park assist sensing at the rear, helping restore the factory parking sensor function when the original unit is no longer operating correctly.

This Standard Ignition parking aid sensor uses a female connector with a rectangular shape, a 6-pin male terminal layout, and a single connector interface for direct replacement service. Part number PPS284 is also referenced in OE-style cross applications for the same rear park assist application.

Key Features

• Rear park assist sensor for 2020-2022 Kia Telluride
• Standard Ignition PPS284 replacement part
• Female connector with rectangular housing
• 1 connector, 6-pin male terminal design
• Built for rear parking aid sensor service

Detailed Description

Standard Ignition PPS284 is a body sensor replacement for the rear parking aid system on the Kia Telluride. It is intended for vehicles in the 2020, 2021, and 2022 model years and supports rear park assist operation by replacing a failed sensor at the original mounting location. If your Telluride shows parking sensor faults or inconsistent rear detection, this part number provides a direct-fit service option for the confirmed application.

This part cross-references BWS284 and PAS1768 for the same application. When searching for a rear parking aid sensor for Kia Telluride, PPS284 is the part number to compare against OE-style listings and interchange references.

What It Helps Address

• Parking sensor warning messages related to the rear sensor circuit
• Loss of rear park assist detection
• Intermittent sensor response during low-speed parking maneuvers
• Damage from impact, road debris, or moisture intrusion at the sensor
• Replacement needs after a failed factory rear parking aid sensor

Installation Notes and Tips

Verify the connector style, terminal count, and rear position before installation. Confirm the vehicle is a 2020-2022 Kia Telluride with rear park assist sensor fitment, and compare the original part number and connector layout to PPS284 before replacement. After installation, clear any stored fault codes and test the rear parking aid system for proper operation.

Quality Assurance

Standard Ignition is a recognized aftermarket brand for electrical and body sensor replacement parts. PPS284 is listed with confirmed fitment for the rear position on select Kia Telluride models and is supported by interchange references for application matching.