Standard Ignition S-1791 ABS Wheel Speed Sensor Wiring Harness - Front Right

ABS Wheel Speed Sensor Harness for GM Front Right

Standard Ignition S-1791 is a direct replacement ABS wheel speed sensor wiring harness for front right applications on select Chevrolet, Pontiac, and Oldsmobile vehicles. It is built to restore a secure electrical connection at the wheel speed sensor while supporting proper routing through the chassis.

For Chevrolet Malibu, Pontiac Grand Am, and Oldsmobile Alero repairs, this harness uses OE-style connectors and terminals to help maintain a water-tight connection at the engine wire harness. The protective sleeve, grommets, and wire clips support clean routing and help reduce wire chafing.

• OE connectors and terminals for a secure, water-tight connection
• Direct replacement design for front right ABS wheel speed sensor wiring
• Protective sleeve helps prevent chafing and short circuits
• Grommets and wire clips support proper mounting and routing
• Glass reinforced plastic resin provides heat and environmental resistance
• Standard Ignition S-1791 for service and repair applications

Detailed Product Overview

This ABS wheel speed sensor wiring harness is built with one male connector, female pin socket terminals, and OE-style construction for accurate electrical transfer. It is a practical repair part for restoring signal integrity between the wheel speed sensor and the vehicle harness on 1997-2005 Chevrolet Malibu, 1999-2005 Pontiac Grand Am, and 1999-2004 Oldsmobile Alero front right locations. Standard Ignition S-1791 is a direct replacement solution for technicians addressing damaged, brittle, or corroded sensor wiring.

This part cross-references Dorman OE Solutions 970-009 for the same application.

Common Repair Uses

• Broken or frayed ABS wheel speed sensor wiring
• Corroded or loose connector terminals
• Intermittent wheel speed sensor signal loss
• Chafed wiring near the chassis or suspension area
• Water intrusion at the sensor connection

Installation Notes and Tips

Verify the front right position before installation and compare the connector style, terminal type, and routing path to the original harness. Inspect nearby clips, grommets, and mounting points so the replacement harness seats correctly and follows the factory route. Standard Ignition S-1791 is intended for direct replacement service on the listed Chevrolet Malibu, Pontiac Grand Am, and Oldsmobile Alero applications.

Quality Assurance

Standard Ignition builds this harness with OE-style connectors and terminals, glass reinforced plastic resin, and a protective sleeve to support reliable electrical connection and environmental resistance in automotive service.