Standard Ignition S20457 Fuel Injection Throttle Body

Electronic Throttle Body for Ford and Lincoln

Standard Ignition S20457 is an electronic fuel injection throttle body assembly for select Ford and Lincoln vehicles. It includes the electronic throttle body seal, throttle position sensor, and idle air control motor for a direct replacement focused on throttle control and idle management.

Compatible With 2019-2024 Ford Edge, 2020-2025 Ford Escape, 2021-2025 Ford Bronco Sport, 2020-2025 Lincoln Corsair, and 2019-2023 Lincoln Nautilus. Factory relearn procedure required after installation.

Key Features

• Electronic throttle body assembly for fuel injection systems
• Includes throttle position sensor and idle air control motor
• Gasket or seal included for the throttle body interface
• Female connector with 6 male blade terminals
• Seal hardware included
• Relearn required for installation

Detailed Description

The Standard Ignition S20457 throttle body is built for vehicles that use electronic throttle control to regulate airflow into the engine. It is a direct-fit replacement for applications such as the Ford Edge, Ford Escape, Ford Bronco Sport, Lincoln Corsair, and Lincoln Nautilus, making it a practical choice when restoring throttle response, idle stability, and drivability. This part cross-references K2GZ9E926A and ETB792 for the same application.

Standard Ignition S20457 is supplied as an electronic throttle body with the seal needed at the mounting interface. It does not include fuel injectors or mounting hardware, and it uses a female connector with six blade terminals. The integrated throttle position sensor and idle air control motor support accurate throttle input and idle control in the original vehicle system.

What It Is Used For

• Restoring throttle response after throttle body wear or contamination
• Addressing unstable or rough idle conditions
• Correcting throttle control faults tied to the electronic throttle body
• Replacing a damaged throttle body seal at the intake connection
• Resolving drivability issues on Ford Edge, Escape, Bronco Sport, and Lincoln Corsair or Nautilus applications

Installation Notes and Tips

Verify connector style, terminal count, and engine application before installation. Clean the mating surfaces thoroughly and install the included seal during assembly. A factory relearn procedure is required after installation, so follow the vehicle-specific service steps to complete throttle calibration and idle relearn.

Quality Assurance

Standard Ignition supplies this throttle body as an OE-style replacement component for electronic fuel injection systems. Confirm fitment by year, make, and model before ordering to ensure proper application.