Standard Ignition S2880 Mass Air Flow Sensor Connector

Mass Air Flow Sensor Connector for Honda and Acura

Standard Ignition S2880 is a weather-sealed mass air flow sensor connector built for direct replacement on a wide range of Honda and Acura applications. It is a 5-terminal, oval connector with a 13-inch harness and 18-gauge wiring for service on damaged, heat-affected, or corroded MAF sensor leads.

Key Features

• Standard Ignition S2880 mass air flow sensor connector
• 5-terminal female blade terminal design with oval housing
• Weatherproof sealed connector construction
• 13-inch harness length with 18 ga. wire
• 1 connector with straight, 0-degree bend angle
• Direct-fit electrical connector for emission control repair

Detailed Description

This Standard Ignition S2880 connector is used to restore the electrical connection at the mass air flow sensor on many Honda and Acura vehicles. It is a direct replacement connector for service work where the original plug is cracked, loose, or no longer making reliable contact. This part cross-references CONA365 and EC2780 for the same application. Compatible vehicle coverage includes Fits 2006-2017 Honda Accord, N/A; Fits 2006-2015 Honda Civic, N/A; and Fits 2007-2016 Acura MDX, N/A, along with additional Honda Odyssey, Pilot, CR-Z, Fit, HR-V, Ridgeline, and Acura TLX, RDX, RLX, ILX, TL, TSX, RL, and ZDX applications. Standard Ignition S2880 is also listed for 2017-2019 Honda Clarity and 2015-2019 Acura TLX coverage.

Common Repair Uses

• Broken or cracked MAF sensor connector housing
• Intermittent sensor signal caused by loose terminals
• Corrosion at the original connector terminals
• Heat damage near the intake or engine harness
• Check engine light concerns related to poor sensor connection

Installation Notes and Tips

Match the 5-terminal oval connector style, terminal gender, and harness layout before installation. Verify wire routing and pin alignment against the original connector, then inspect the mating sensor for bent pins or contamination before reconnecting. This part is a weatherproof sealed connector, but the housing itself is not weather resistant.

Quality Assurance

Standard Ignition S2880 is built as an OE-style replacement electrical connector for emission control service. It is specified for direct-fit repair use on confirmed Honda and Acura applications.