Standard Ignition S2986 ABS Wheel Speed Sensor Connector - Front Left, Rear or Rear Left

ABS Wheel Speed Sensor Connector for Kia, Hyundai, and Mazda

Standard Ignition S2986 is an ABS wheel speed sensor connector built for direct electrical repair at the wheel speed sensor harness. It features a female oval housing with a 0-degree bend angle, 20-gauge wiring, and a 43 cm (17.5 in.) harness length for service on select Kia Sedona, Hyundai Entourage, and Mazda MPV applications.

Key Features

• Female ABS wheel speed sensor connector with oval housing
• 2 blade terminals with male terminal ends
• 20 ga. wire construction for sensor circuit repair
• 43 cm (17.5 in.) harness length for routing flexibility
• 0-degree bend angle and 1 1/4 in. housing length
• Direct-fit electrical connector for brake system sensor service

Detailed Description

Standard Ignition S2986 is used to restore the electrical connection between the ABS wheel speed sensor and the vehicle harness when the original connector is damaged, corroded, or no longer locking securely. This connector is shaped for a clean fit at the sensor interface and uses a 2-terminal blade design to match the original circuit layout on supported vehicles. It is a practical repair part for ABS wheel speed sensor connector replacement on 2014 Kia Sedona rear, 2002-2012 Kia Sedona rear, 2009-2010 Hyundai Entourage front left, 2007-2008 Hyundai Entourage rear, and 1996-1998 Mazda MPV rear left applications. This part cross-references CONB11454 and EC2889 for the same application.

What It Helps Fix

• Broken or brittle ABS sensor connector housing
• Corrosion at the wheel speed sensor electrical connection
• Intermittent ABS warning light caused by poor terminal contact
• Open or unstable wheel speed sensor signal at the harness
• Damaged connector locking tabs or worn blade terminals

Installation Notes and Tips

Verify connector shape, terminal style, and position before installation. Match the vehicle side and sensor location exactly: Fits 2014 Kia Sedona, rear; Fits 2002-2012 Kia Sedona, rear; Fits 2009-2010 Hyundai Entourage, front left; Fits 2007-2008 Hyundai Entourage, rear; Fits 1996-1998 Mazda MPV, rear left. Inspect the mating sensor connector and harness for heat damage, corrosion, or broken insulation before completing the repair. Confirm secure terminal engagement and proper routing so the harness does not rub or pull at full suspension travel.

Quality Assurance

Standard Ignition replacement electrical connectors are built for service work where accurate terminal fit and dependable sensor communication matter. S2986 is specified for the listed vehicle applications and supports a clean repair of the ABS wheel speed sensor circuit.