Standard Ignition S3150 Throttle Position Sensor Connector

Throttle Position Sensor Connector for Ford Applications

Standard Ignition S3150 is a throttle position sensor connector built for Ford fuel and engine management repairs. It features a female round connector body with 3 male pin terminals, 18-gauge wiring, and a 13.5-inch harness length for service on select Ford trucks and vans.

Fits 1985-1997 Ford F-250, N/A; Fits 1986-1997 Ford F-350, N/A; Fits 1986-1996 Ford E-150 Econoline, N/A; Fits 1986-1996 Ford E-150 Econoline Club Wagon, N/A; Fits 1986-1996 Ford E-250 Econoline, N/A; Fits 1986-1996 Ford E-350 Econoline, N/A; Fits 1986-1996 Ford E-350 Econoline Club Wagon, N/A; Fits 1985-1996 Ford F-150, N/A; Fits 1985-1995 Ford Bronco, N/A; Fits 1986-1991 Ford E-250 Econoline Club Wagon, N/A.

• Female round connector with 3-pin male terminal interface
• 18-gauge wire construction for throttle position sensor wiring repair
• 13.5-inch harness length for routing in engine bay service locations
• 2-inch housing length with 0-degree bend angle
• Direct-fit electrical connector for select Ford F-150, F-250, F-350, Bronco, and Econoline models

Detailed Product Overview

Standard Ignition S3150 is a throttle position sensor connector used in air and fuel delivery electrical repairs where the original connector is damaged, heat-affected, or no longer making a stable connection. The round female housing and 3-terminal pin layout match the sensor-side connection used on the listed Ford applications, including Ford F-150, Ford F-250, Ford F-350, Bronco, and Econoline vans. This part cross-references CONB10880 and EC3175 for the same application.

Common Repair Uses

• Broken or brittle throttle position sensor connector housing
• Intermittent TPS signal caused by loose terminal contact
• Corrosion at the connector terminals
• Heat-damaged wiring near the throttle body
• Engine drivability issues traced to damaged sensor wiring

Installation Notes and Tips

Verify the connector shape, terminal count, and wire layout against the original part before installation. Match the round female connector and 3-pin pin terminal configuration to the vehicle harness, and route the 34 cm harness to avoid tension at the throttle body area. Confirm secure terminal engagement and inspect adjacent wiring for heat or abrasion damage during repair.

Quality Assurance

Standard Ignition replacement electrical connectors are built for service work on listed Ford applications and are identified by OE-style fitment details for accurate repair selection. Part number S3150 is specified for direct application matching on the vehicles shown above.