Standard Ignition SK117 Fuel Injector Seal Kit

Fuel Injector Seal Kit for Chevrolet Cruze

Restore a proper seal at the fuel injector with Standard Ignition SK117. This fuel injector seal kit is built with high-temp Viton O-rings to maintain sealing performance in demanding heat and operating conditions, making it a practical choice for 2011-2015 Chevrolet Cruze fuel system service.

Standard Ignition SK117 is designed for direct service use on the injector seal interface and helps support consistent fuel delivery by sealing between mating surfaces. It is a focused repair part for Chevrolet Cruze fuel injector maintenance when the original seals are worn, hardened, or leaking.

Key Features

• Fuel injector seal kit for air and fuel delivery service
• High-temp Viton O-rings for heat-resistant sealing
• Brown and blue seal colors for easy identification during service
• Rubber construction for injector sealing applications
• Designed for 2011-2015 Chevrolet Cruze applications
• Standard Ignition SK117 for direct replacement service

Detailed Description

Standard Ignition SK117 is a fuel injector seal kit engineered for sealing the injector assembly at critical contact points. The O-rings are made from high-temperature Viton material to help maintain seal integrity during extreme heat exposure, while the assorted sizing supports faster installation during injector service. This kit is intended for one injector application and uses MFI seal type construction for fuel injector sealing needs. If you are servicing a 2011-2015 Chevrolet Cruze and need a replacement fuel injector seal kit, SK117 provides the sealing components required for that repair.

This part cross-references Standard Motor Products (e.g., 1G1497, 2-12373) for the same application.

Common Repair Uses

• Fuel odor caused by leaking injector seals
• Hard starting related to injector seal leakage
• Visible fuel seepage around the injector body
• Rough idle from compromised injector sealing
• Maintenance replacement during injector service on a Chevrolet Cruze

Installation Notes and Tips

Inspect the injector bore and mating surfaces before installation. Clean away old seal material, dirt, and fuel residue so the new O-rings seat evenly. Lightly lubricate the seals with clean engine oil or approved fuel-system lubricant before assembly, and verify the injector is fully seated after installation. Confirm the seal profile matches the injector design used on your vehicle before beginning service.

Quality Assurance

Standard Ignition states that the O-rings are quality tested for durability under extreme vehicle operation. The Viton material selection supports sealing performance in high-heat conditions commonly seen in fuel system service.