Standard Ignition SLS-300 Brake Light Switch

Brake Light Switch for Chevrolet Bel Air

Standard Ignition SLS-300 is a brake light switch built for dependable stoplamp signal operation in classic Chevrolet applications. It uses a male connector, two male bullet terminals, and a single switch function to support accurate brake light activation on 1951-1952 Chevrolet Bel Air models.

Key Features

• Brake light switch / stoplight switch function
• Male connector with 1 connector interface
• 2 male bullet terminals for electrical connection
• Brass or high-impact composite housing design, depending on application specification
• Special spring and contact arrangement to reduce arcing
• Copper alloy conductors for strong electrical conductivity and low resistive loss
• 100% tested for mechanical and electrical switching performance

Detailed Description

Standard Ignition SLS-300 is engineered for direct stoplight switch service where consistent brake lamp response matters. The internal contact design is intended to limit arcing and support longer service life, while copper alloy conductors help maintain stable current flow. This part cross-references Dayco 72496 for the same application. For buyers searching for a 1951-1952 Chevrolet Bel Air brake light switch or a Standard Ignition SLS-300 stoplight switch, this part matches the listed vehicle fitment and electrical configuration.

What It Helps Solve

• Brake lights that do not illuminate when the pedal is pressed
• Intermittent stoplamp operation
• Delayed or inconsistent brake light activation
• Electrical switching issues at the brake pedal circuit
• Wear-related contact problems in the stoplight switch

Installation Notes and Tips

Verify connector style, terminal type, and switch function before installation. Confirm the brake pedal switch location and electrical routing on the vehicle, then compare the removed part to Standard Ignition SLS-300 for terminal and connector match. After installation, test brake lamp operation with the ignition and pedal applied to confirm proper switching.

Quality Assurance

Standard Ignition manufactures original equipment ignition products with quality control maintained throughout the production process, from component selection to finished part. SLS-300 is tested to verify both mechanical and electrical switching performance.