Standard Ignition SLS-363 Brake Light Switch

Brake Light Switch for Land Rover Applications

Standard Ignition SLS-363 is a 12-volt brake light switch built with a plastic body, spring activation, and a push-in attachment method. It uses a single rectangular connector with 3 terminals, making it a direct electrical replacement for select Land Rover brake pedal switch applications.

Compatible with 2002-2005 Land Rover Freelander and 2002-2003 Land Rover Range Rover, this brake light switch is a practical choice when the brake lamps, cruise cancel signal, or stoplamp circuit need attention. The SLS-363 is also cross-referenced to SL913 and SL2103 for the same application.

Key Features

• Brake light switch for 12-volt vehicle electrical systems
• 3-terminal design with blade terminals
• Female connector with rectangular 1-connector layout
• Spring activation style for pedal-operated switching
• Push-in attachment method for select Land Rover brake switch mounts
• Plastic housing for standard under-dash electrical use
• Standard Ignition SLS-363 replacement part number

Detailed Description

Standard Ignition SLS-363 is a brake light switch engineered for vehicles that use a spring-actuated, push-in style stoplamp switch. It is built with a female rectangular connector, male blade terminals, and a 12-volt electrical rating to match the original circuit design on select Land Rover models. For drivers searching for a brake light switch for 2002-2005 Land Rover Freelander or a brake pedal switch for 2002-2003 Land Rover Range Rover, this part provides the correct electrical interface and mounting style for those applications.

This part number, SLS-363, is a direct replacement option for stoplamp circuit service where the original switch has worn contacts, inconsistent pedal response, or connector-related failure. It cross-references Monroe Shocks & Struts part numbers SL913 and SL2103 for the same application.

Common Issues This Part Can Address

• Brake lamps staying off when the pedal is pressed
• Brake lights remaining on after pedal release
• Intermittent stoplamp operation
• Cruise control cancel signal problems tied to the brake switch circuit
• Electrical connector or terminal wear at the brake pedal switch

Installation Notes and Tips

Verify connector shape, terminal count, and push-in mounting style before installation. Inspect the brake pedal area for proper switch alignment and confirm the pedal contacts the spring-actuated switch correctly after replacement. Because hardware and a wiring harness are not included, reuse the existing vehicle components when applicable and confirm the brake lamps operate normally after installation.

Quality Assurance

Standard Ignition SLS-363 is built to match the specified electrical and mounting requirements for the listed Land Rover applications. Confirm fitment against the vehicle year, make, and model before ordering.