Standard Ignition SS-708 Starter Solenoid

Starter Solenoid for Nissan Pulsar NX

Standard Ignition SS-708 is a 12-volt starter solenoid built for electrical starting system service. It uses a female connector, a single connector interface, and stud-and-blade terminals to support direct replacement needs on the listed application.

• 12-volt starter solenoid for starting system repair
• Female connector with 1 connector interface
• 3 terminals with stud and blade terminal type
• Male terminal gender for the specified electrical connection
• Compact 2.2-inch overall length
• Fits 1989 Nissan Pulsar NX, w/ Wire; w/ Federal Emissions

Application Details

Standard Ignition SS-708 is a starter solenoid for electrical charging and starting system service on the 1989 Nissan Pulsar NX with wire and federal emissions. This part number is also referenced as SS-708 and cross-references Spectra Premium ST358 for the same application. Use it when replacing a worn or failed solenoid that affects starter engagement, electrical switching, or crank signal transfer in the starting circuit.

Common Repair Uses

• No-crank condition caused by solenoid failure
• Intermittent starter engagement during key start
• Clicking at start with poor electrical transfer
• Starter circuit switching problems on the Nissan Pulsar NX
• Replacement for a damaged original solenoid on the listed vehicle

Installation Notes

Verify connector style, terminal layout, and mounting location before installation. Match the 12-volt electrical system and confirm the vehicle configuration is 1989 Nissan Pulsar NX with wire and federal emissions. Inspect related starter cables, terminals, and grounds during service to avoid repeat starting issues.

Quality Assurance

Standard Ignition supplies electrical replacement parts for starting and charging system repair. SS-708 is built to match the listed application details and electrical connection format for service on the specified vehicle.