Standard Ignition TH407 Throttle Position Sensor

Throttle Position Sensor for Mitsubishi Lancer

Standard Ignition TH407 is a throttle position sensor for select 2002-2007 Mitsubishi Lancer applications. It provides the throttle position signal the engine control system uses to monitor throttle movement and manage drivability-related inputs.

Key Features

• Female connector with 1 plug-in connection
• 3 male blade terminals for direct electrical interface
• Built for throttle position sensing in emission control systems
• Direct-fit application for select Mitsubishi Lancer models
• Standard Ignition TH407 for OE-style replacement needs

Detailed Description

This throttle position sensor is built around a 1-connector, plug-in design with a female connector and 3 male blade terminals. Standard Ignition TH407 is used to report throttle angle to the vehicle control system, helping maintain accurate throttle input feedback on 2002-2007 Mitsubishi Lancer models. If you are searching for a throttle position sensor for Mitsubishi Lancer 2002-2007 or a Standard Ignition TH407 replacement, this part matches the listed electrical configuration and fitment.

This part cross-references 2-60029 and EC3363 for the same application.

What It Helps Address

• Throttle position signal errors
• Erratic throttle response
• Check engine light concerns related to throttle input
• Idle quality issues tied to incorrect throttle feedback
• Driveability problems caused by inconsistent sensor output

Installation Notes and Tips

Verify connector style, terminal count, and mounting location before installation. Confirm the vehicle is a 2002-2007 Mitsubishi Lancer and compare the original sensor’s electrical layout to Standard Ignition TH407. After installation, clear diagnostic trouble codes and confirm throttle signal readings with a scan tool.

Quality Assurance

Standard Ignition manufactures emission control sensors for service replacement applications. TH407 is listed for direct fitment on select Mitsubishi Lancer models and follows the specified connector and terminal configuration for the application.